BROSA Haruki Wide Sideboard User manual

ASSEMBLY GUIDE
Haruki Wide Sideboard
v1.0

Components
Upon unpacking your sideboard from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new sideboard.
Sideboard body x 1
Hardware
What you need
Adjustable shelf x 3
A x 12
Spec:
B x 2
Spec:
C x 1
Spec:
D x 2
Spec: Ø4 x 17mm
1

Step 1 e sideboard is already assembled. is step shows you
how to insert the adjustable shelving inside the unit.
1.1 Insert a wood shelf supporter (A) into each desired
hole inside the unit, making sure that they are level.
1.2 Tilt the adjustable shelving (1) to a suitable angle
and slide them into the unit, making sure rst that the
holes on the shelves are facing down so that the pins on
the wood shelf supporters (A) t inside.
Enjoy your new sideboard!
Step 1.1
Step 1.2
Step 1.2
A x 12

Step 2 e following steps are to instruct how to adjust the
hinges if needed.
2.1 Lateral adjustment by screw adjustment.
2.2 Front-to-Back by slackening and retightening the
hinge-arm mounting screw.
2.3 Vertical adjustment via slots on mounting plate by
slackening and retightening the screws on the
mounting plate.
Step 2.1 Step 2.2
Step 2.3

Step 3
Step 3.1
Step 3.2
e following steps are to intruct how to remove and
insert the drawers.
3.1 To remove the drawers, pull them out one by one
and unlock by lifting up both locking pads located on
either side of the drawers and then remove it.
3.2 To insert the drawers, align it to the unit one by one
and push back inside and once the drawer is in place
the locking pads on both sides will automatically lock.

Step 4 e following steps are to intruct how to install the
anti-tip kit (optional) that came with the unit. To
prevent injury and property damage from unexpected
tipping of furniture we highly recommend installation
of the anti-tip kit.
Attaching furniture to the wall with anti-tip kits:
4.1 Determine where the piece is to be placed and
mark the location on the wall for the mounting bracket
screw holes.
4.2 Drill the hole and use the appropriate wall plug that
is suitable for your walls composition.
Warning: Before drilling check the wall for hidden
pipes and cables.
4.3 Attach the mounting bracket vertically to the wall
using an appropriate fastener and two wall plugs that
are suitable to your wall and then tightly secure.
4.4 Next using the short screws, attach the second
bracket to the back of the furniture’s top.
4.5 Lace the nylon strap down through the brackets
before sliding the thin end of the strap through the
receiving end on the nylon strap and pulling it tight to
secure the furniture to the wall.
e diagram for these set of instructions is on the
following page.
Note that hardware may loosen over time, therefore
periodically check that all connections are tight and
re-tighten as necessary.
B x 2
C x 1
D x 2

Step 4 e diagram depicting Step 4.