BROSA Robert Wing Back Armchair User manual

ASSEMBLY GUIDE
Robert Wing Back Armchair
v1.0

Components
Upon unpacking your armchair from it’s delivery box, you should have one
single component (the body of the armchair). Additional components are
packed inside the body, you will learn how to access and utilise these
components in the next steps.
Turn the armchair body so that the underside is facing you. Remove the
cover from the base of the armchair to reveal a hidden compartment where
you’ll nd the rest of the parts of the armchair. Take these out and leave the
cover o as you need access to the underside of the chair to t the legs.
Unpacking
A x 2
(Front leg) (Bolt)
(Flat washer)
(Spring washer)
(Allen key)
(Back leg)
(Back leg)
B x 1
C x 1
D x 8
E x 8
F x 8
G x 1
Armchair body x 1
1
Hardware

Fit a front leg (A) into a slot so that the face with
insert nuts are facing inward. Fit a spring washer (F)
to a bolt (D), followed by a at washer (E). Turn the
bolt with the allen key (G) until it is secure but do not
tighten yet. Repeat for the other front leg.
Fit a back leg (B) into a slot so that the face with
insert nuts are facing inward. Fit a spring washer (F)
to a bolt (D), followed by a at washer (E). Turn the
bolt with the allen key (G) until it is secure but do not
tighten yet. Repeat for the other back leg.
Step 1
Step 2
F x 4
G x 1
E x 4
D x 4
A x 2
E x 4
F x 4
D x 4
C x 1
B x 1
G x 1
A
A
B
C

G x 1
Step 3 Gently lift the armchair and place upright on a level
surface, then sit on the armchair and shift your
weight around until the legs are level and the chair
does not rock. en use the allen key (G) to tighten
all the bolts and replace the cover on the underside
of the armchair body to conceal the hidden com-
partment. Enjoy your new armchair!