BROSA Mita Console Table User manual

ASSEMBLY GUIDE
Mita Console Table
v1.0

Components
Upon unpacking your console table from it’s delivery box, you should have
the separate pieces shown below. Follow the steps on the next pages to
assemble your new console table.
Leg x 4
Table top x 1

Hardware
What you need
A x 8
Spec: Ø12mm x 70mm/Ø8mm
C x 8
E x 1
Spec: Ø8mm x 13mm x 1.8mm
Spec: Ø8mm x 19mm x 1.2mm
Spec: Ø8mm x 110mm
B x 1
F x 1
Spec: Ø8mm x 88mm x 2mm
D x 1
Spec: M8

Step 1
Step 2
E x 8
A x 4
Insert the cross dowel (A) into the hole at the top of
each leg (2) making sure that it is facing the correct
direction.
Insert a threaded bolt (E) into the hole on the side of
each leg (2), screwing it tightly in place.

Step 3
Step 4
C x 8
D x 8
B x 8
E
Align a leg (2) to the underside of the table top (1)
making sure the threaded bolt protruding from the leg
ts into the hole in the frame. Fit a at washer (B) to
the bolt (E) followed by a spring washer (C) and a hex
nut (D). Use the spanner (F) to tighten the nut in place.
Repeat for the remaining legs.
Gently lift the table and place upright on a level sur-
face. Enjoy your new console table!
F x 1