BROSA Loki Armchair User manual

ASSEMBLY GUIDE
Loki Armchair
v1.0

Components
Upon unpacking your chair from it’s delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Chair body x 1
Lift the seat cushion o the chair to reveal a hidden compartment where
you’ll nd the rest of the parts of the chair. Take these out and replace the
seat cushion back on the chair.
Unpacking
A x 2 (Front Leg)
B x 2 (Back Leg)
C x 12 (Bolt)
D x 12 (Spring Washer)
E x 12 (Plastic Washer)
F x 1 (Allen Key)

Step 1 Starting with the front legs, align a leg (A) so that the
screw slots are overlapping. Fit a plastic washer (E)
to a bolt (C) followed by a spring washer (D) and t
it into one of the screw holes. Repeat for the
remaining two screws to t the leg to the body of the
chair. Turn the bolt with the allen key (F) until it is
secure but do not tighten yet. Repeat for all four legs.
Please note that the back legs (B) are both the same
and are to only go at the back of the chair.
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
B x 2
A x 2
C x 12
E x 12
D x 12
F x 1
D E C F
AA
B
B

Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(F) to tighten all the bolts and replace the cover on
the underside of the chair body to conceal the
hidden compartment. Enjoy your new armchair!
F x 1