BROSA Walter Dining Table User manual

Walter
Dining Table
ASSEMBLY GUIDE
V1

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
Hardware
What You Need
Table Top x 1
Leg Frame x 4
A x 12
(M8 x 40)
B x 12
(Ø8 x Ø18)
C x 24
(M3.8 x 18)
D x 8
(15 x 15)
E x 1
(5#)
②
①

Align a leg frame ② with the bottom of the table
top ①. Make sure bolt holes on each side
overlap.
Fit a washer B to a bolt A and then insert the bolt
into a hole. Tighten the bolt with your hand until it
is finger-tight.
Repeat this for the remaining holes and then
repeat the process for the other leg frames.
Step 1
Ax 12
②
①
Bx 12
A
B

With the bolts loosely screwed in place, push the
leg frames a bit further so that they don’t hang off
the edges of the table top. Once this is done,
tighten the bolts with the Allen key E.
Step 2
Ex 1
E

Insert screws Cinto holes on the side wings and
tighten them with a screwdriver.
Remove the cover of the foot pads Dand attach
them to the leg frames.
Step 3
Cx 24
Dx 8
C

Flip the piece of furniture and place it upright on
a level surface. Enjoy your new Walter Dining
Table!
Step 4

User Recommendation
Assembly
1. Assemble furniture using our Assembly Guides. You can find them at
support.brosa.com
2. Do not dispose of any packaging or contents of the shipping carton
until assembly is completed to avoid accidentally discarding small
parts or hardware.
Placement
1. Keep furniture on flat, level ground. Placing it unevenly may cause
deformation.
2. Do not place heavy objects on furniture.
3. When repositioning furniture: lift, don’t drag.
4. Keep sharp objects away. Don’t drag items along the surface.
5. Do not stack furniture.
Cleaning and Maintenance
1. Clean furniture regularly with a white soft cloth. Slightly damp fabrics
help absorb dust, but ensure you dry it once you’re done.
2. Clean spills and stains immediately with a clean cloth. Nail polish
and nail polish remover can erode furniture. Dab don’t rub these stains.
3. Take care when using pens or markers on furniture. Keep liquids
away as they may damage the finishing.
4. Avoid harsh cleaning chemicals such as alcohol or gasoline
solvents. Avoid using sponges or dirty cloths.
5. Cover furniture that isn’t being used to protect from dust and
ageing.
6. Re-tighten screws and attachments when they loosen.
Exposure
1. Use protective coasters and mats between hot items and furniture.
2. Keep furniture away from intense direct sunlight. Exposure can
cause cracks or discolouration.
3. Severe changes in temperature and humidity can accelerate ageing.
Keep furniture at least 50cm from heat or air conditioning.