Cisco TelePresence SX10 User manual

Place Call
To enter numbers just
press the corresponding
keys on the remote.
To invoke the virtual
keyboard, use the left
arrow Cursor key to move to the 123 eld. You may now
move about the keyboard and select characters. Press OK
to select a character.
Select the green Call eld on the scren or press the green
Call button on the remote to place the call
Use the Cursor keys of
the remote control to
select the Search or Dial
eld, as outlined.
Make sure Call is selected
and press OK or the green
Call button on the remote
control.
Place Call from Contact List Change the Screen Layout
Receive or Decline Calls
Once an entry has been
located, press OK on the
remote control to invoke
the Call menu. Then press
the green Call button or
the OK button on the remote control to place the call.
Use the Cursor keys on
the remote control to
go between Favorites,
Recents and Directory
and then down in one of
the lists.
Make sure Call is selected
and press OK or the green
Call button on the remote
control.
Use the Arrow keys on
the remote control to
move horizontally to the
new layout you would like
to use and press OK.
Navigate to Layout ( ) in
the upper right corner and
press OK on the remote
control. This icon will
appear only when relevant.
Quick Reference Guide
Cisco TelePresence SX10, SX20
CE8.0
If someone calls you,
you may accept, decline
or ignore the call.
If you decline the call,
busy information will be
sent to the calling party.
You may also use the
keys on the remote
control directly.

The Screen and the Remote ControlContent Sharing
Use this feature to share content on your PC in a call or outside a call.
Use this to place
calls
Use this to share
content
Access Standby mode,
System information and the
Do Not Disturb feature
Access the
Camera Control
menu
This icon appears to
indicate that Proximity
has been enabled for
this system
Volume control and Increase/Decrease control
Field selector/
Cursor keys
Go back one step Microphone mute/
unmute
Reject incoming call /
End call / Cancel /
Back to Home screen
(outside calls)
Place call/
Accept incoming call
OK/Enter
Keypad
1 2 3
4 5 6
7 8 9
*0#
.@
pqrs tuv wxyz
defabc
ghi jkl mno
Use the Cursor controls to move about
the screen and press OK/Enter to open
the selected menu eld.
Use the Cancel key to exit a menu (and
return to the Home screen) undoing
any changes. Use the Back key to go
just one step back.
When set to Do Not Disturb, ringtones
are muted and call attempts made by
others to reach you, will appear as
missed calls. You may, however, place
calls as much as you like.
Make sure your
presentation source
is connected and
On. Select Share
and press OK on the
remote control.
Select the source to be
shared and press OK
on the remote control.
The size of the shared
image is controlled by
means of the Minimize/
Maximize eld. Select
this and press OK on
the remote control, if
needed.
To stop sharing content,
select Stop sharing
and press OK on the
remote control.
Quick Reference Guide
Cisco TelePresence SX10, SX20
CE8.0
D1535501 Quick Reference Guide, SX10/SX20 with remote control.
Produced in November 2015 for CE8.0.
All contents © 2014—2015 Cisco Systems, Inc. All rights reserved.