CLARKE GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have een a used or tampered
with in any way, or not used for the purpose for which it was intended.
Faulty goods should e returned to their place of purchase, no product can e
returned to us without prior permission.
This guarantee does not effect your statutory rights.
Thank you for purchasing this CLARKE Electronic Digital Safe, which is designed
for use in the home and office, as well as in boats and caravans etc.
Battery Installation
Open the safe door using key supplied, see key operation.
The attery compartment is found on the ack of the door. Slide the cover off in
direction indicated, install atteries o serving correct polarity, refit cover and test
efore closing door.
Operation
Open Safe (Keypad)
The entry code
(159)
is factory set. To open the safe, enter
159
on the numeric
keypad followed y utton
B
, the green LED will illuminate and the kno can e
rotated fully clockwise to release the olts. The door can now e opened. If an
incorrect code is entered three times, an audi le alarm will sound for 20 seconds. The
panel then resets, the correct code can now e entered, if an incorrect code is
entered a further three timesthe alarm will sound for five minutes efore resetting.
NOTE:
each time a button is pressed an audible beep will sound and the amber LED
will illuminate.
Close Safe
To close the safe, simply close the door and rotate the kno anticlockwise, the door
locks automatically, test the lock y attempting to turn the kno clockwise.
Change Entry Code
To change the entry code, open the safe door, using either the key or keypad. Press
the red utton (Fig. 2), the am er LED will illuminate, enter the new code on the
numeric key pad followed y utton
A.
NOTE:
the entry code can be a minimum of three and a maximum of eight digits. If the
code entered is less than three or more than eight digits, an audible warning will be
LEDs
Red Amber
Knob umeric Key Pad
Override Key Cover Battery Compartment
Red Button
Fig. 1
Fig. 2
UnlockLock
Green
heard.
Open Safe (Key Operation)
In the event of attery or electronic failure, the safe can e opened using one of the
two keys supplied.
Carefully remove the override cover y prising open with a thin laded knife or similar,
once removed the key lock is exposed. Insert the key and rotate fully anticlockwise,
now rotate the kno fully clockwise to open as efore. The door can e locked again
y reversing the procedure.
NOTE:
When the
Red
and
Amber
LEDs are both illuminated, this indicates that the
batteries need replacing.
IMPORTANT
Never leave the keys inside the safe
