Connects2 CAM-MB2-AD User manual

www.connects2.com
CAM-MB2-AD
Mercedes Camera Add On Interface
for NTG 5.0 head units
INSTRUCTION MANUAL

www.connects2.com
2
ABOUT THIS PRODUCT...
CAM-MB2-AD
This product allows the addition of an aftermarket reverse camera to the OEM
NTG 5.0 screen in a range of Mercedes vehicles.
Product Contents
1. Interface
2. Harness x 3
3. Instruction
Application
B Class 2011> (W246)
C Class 2014> (W205)
CLA 2014> (C117)
CLS 2015> (W219)
E Class 2015> (W213)
Prior to installation
Read the manual prior to installation. Technical knowledge is necessary for installa-
tion. The place of installation must be free of moisture and away from heat sources.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2
1
2
3
4
Fig 1.
1. Interface
2. Vehicle power T-harness
3. Camera harness
4. LVDS harness

www.connects2.com
3
FITTING GUIDE
1. Please ensure the ignition is switched off and the key removed from the
ignition. Remove the OEM NTG 5.0 head unit.
2. Disconnect the original grey LVDS connector from the head unit as shown
and connect the LVDS harness from the interface (Fig 1, 4). Disconnect the
vehicle power harness (quadlock connector) and connect the male end of
the supplied vehicle power T-harness (Fig1, 2).
3. Plug the original grey LVDS connector removed in step 2, into the green
LVDS connector on the interface. Connect the white 5 way connector from
the other end of the supplied LVDS cable (Fig 1, 4) to the interface. Connect
the black 8 way connector of the vehicle power T-harness (Fig 1, 2) to the
interface.

www.connects2.com
4
FITTING GUIDE
5. Connect the white 16 way camera harness (Fig 1, 3) to the interface. Make
connections as follows:
Wire Colour Function (Label)
Black Ground (GND)
Red Accessory 12V Out (Acc Out)
Yellow Batt + Out (+B Out)
Purple Camera power out 12V (Cam Out)
Blue Left turn signal out (L-Turn Out)
Pink Right turn signal out (R-Turn Out)
White Reverse signal in (Trig in). Required for
manual transmission vehicles only.
Yellow (RCA) Front camera video in (Front Cam)
6. Connect the vehicle power
harness to the female connector or
the vehicle power T-harness (Fig 1, 2).
Test for correct operation and
re-install the OEM head unit.
4. Set the dipswitches on the interface according to your required setup.
Dipswitch On/Off Function
1 Off C Class
On B Class, CLA, CLS, E Class
2 Off Front camera uninstalled
On Front camera installed
3 Off Guidelines on
On Guidelines off (external trigger only)
4 Off Resolution 7.4 Inch 800 x 480
On Resolution 8.4 inch 960 x 480