Connects2 Aerpro APVAU12 User manual

www.aerpro.com
APVAU12
Audi Camera Add On Interface
INSTRUCTION MANUAL

www.aerpro.com
2
APVAU12
This product allows the addition of an aftermarket reverse camera to the OEM
screen in a range of Audi vehicles with Concert/Symphony head units.
Product Contents
1. Interface
2. Harness x 3
3. Instruction
Prior to installation
Read the manual prior to installation. Technical knowledge is necessary for installa-
tion. The place of installation must be free of moisture and away from heat sources.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Aerpro can not be held responsible for the installation of this product.
Technical Support
Aerpro want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Aerpro, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: intranet.tdj.com.au/
support
ABOUT THIS PRODUCT...
1
2
3
4
Fig 1.
1. Interface
2. Vehicle power/CAN-Bus harness
3. Camera harness
4. LVDS harness

www.connects2.com 3
FITTING GUIDE
1. Remove the Concert/Symphony head unit.
2. On the rear of the upper dash display, disconnect the LVDS
connector (circled). Connect this into the female connector of the supplied
LVDS harnesss (Fig 1, 4). Connect the male end back into the connector on
the rear of the upper dash display.
3. Locate the fuse box on the side of the dashboard. Take off the cover and
locate the 46 way beige connector with the pink latch. Disconnect this and
replace with the supplied vehicle power/CAN-Bus harness (Fig 1, 2). Connect
the ying red wire to an ACC fuse and the black wire to Ground.

www.aerpro.com
4
FITTING GUIDE
4. Set the dipswitches on the interface according to your required setup.
Dipswitch On/Off Function
1 Off Radar Image Enabled
On Radar Image Disabled
2 Off Front Camera Off
On Front Camera On
3 Off Guidelines on
On Guidelines off
4 Off Not Used
On Not Used
5. Connect the white 16 way camera harness connector (Fig 1, 3) to the
interface. Make the camera connections as follows:
Wire Colour Function (Label)
Red Accessory 12V Out (Cam Acc)
White Reverse signal in (Trig in)
Yellow (RCA) Front camera video in (Front Cam)
Yellow (RCA) Rear camera video in (Rear Cam)