dams Connex COU1600OL User manual

COU1600OL
Connex 1600mm Outer Leg Frame
22.01.2017
1 2 3 4 5 6
1

1,2,3...
TOOLS REQUIRED
FOR ASSEMBLY
DONT STRUGGLE
2 MAN LIFT
ALWAYS HANDLE
ITEMS WITH CARE
IF UNSURE CALL
FOR ASSISTANCE
KEEP FITTINGS AWAY
FROM CHILDREN
2

Please check that you have all the Components!
3
1 2+ 3 4+
5 6+
1600mm Outer Leg Frame Fixed Length Beam
1200 / 1400 / 1600mm
Desk Top
1200 / 1400 / 1600mm
Please check that you have all the Fittings! (Fittings supplied with leg frames)
1 2+
1600mm Outer Leg Frame
x 8
M6x60mm Connect Bolt
x 20
M6x10mm Countersunk Bolt
x 8
M6 Nylon Insert
4mm Allen Key

4
2
Step 2
Attach the second beam to the
end leg using the M6 bolts
provided.
Loosely thread the bolts into
the face of the leg before
threading the bolts to the
underside of the leg.
Once all bolts are threaded you
can fully tighten them using the
4mm Allen Key.
1
Step 1
Attach the first beam to
the end leg using the M6
bolts provided.
Loosely thread the bolts
into the face of the leg
before threading the
bolts to the underside of
the leg.
Once all bolts are
threaded you can fully
tighten them using the
4mm Allen Key.
x 5
x 5

5
3
Step 3
Attach the remaining outer leg
frame using the same method
as before.
Attach the beams to the end
leg using the M6 bolts
provided.
Loosely thread the bolts into
the face of the leg before
threading the bolts to the
underside of the leg.
Once all bolts are threaded
you can fully tighten them
using the 4mm Allen Key.
If you are assembling this as part of a larger configuration please
refer to the intermediate leg frame assembly instructions before
proceeding with the next steps.
x 10

6
4
Step 4
Insert the nylon inserts into the pre drilled
holes on the underside of the desktop.
The illustration below shows which pre drilled
holes should be used.
Repeat this step for all desktops.
x 4
If horizontal cable management is being added please refer to the
drop down cable tray assembly instruction before proceeding
with the next steps.
This will make the installation process much easier then trying to
install the cable trays once the desktops are attached.

6
Step 6
Attach the desktop using the
60mm connect bolts as shown.
Loosely thread all the bolts to
ensure that no bolts become
cross threaded before fully
tightening.
5
Step 5
Position the first desktop on the
frame aligning the nylon inserts
with the slotted holes .
7
x 4

8
8
Step 8
Attach the desktop using the
60mm connect bolts as shown.
Loosely thread all the bolts to
ensure that no bolts become
cross threaded before fully
tightening.
7
Step 7
Position the remaining desktop
on the frame aligning the nylon
inserts with the slotted holes .
x 4