dams Benotto BEN50001 User manual

ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS
BEN50002
BEN50001
60mm
B-4 PCS
Screw
C-4 PCS
Spring washer
D-4 PCS
washer
E-1 PC
Allen key
A-4 PCS
Legs

1
2
3
Please note the fixing screws are located in their fixing points if not found in the parts bag.
Should you require any assistance in assembling your goods please contact customer services
on 0151 548 7111 between 9am/4:30pm.
Do not tighten bolts fully until you have completed assembly.
● DO NOT STAND ON THIS CHAIR.
● DO NOT USE THIS CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE FIRMLY SECURED.
● FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY.
● IF PARTS ARE MISSING, BROKEN, DAMAGED OR WORN, STOP USING THIS PRODUCT UNTIL REPAIRS ARE MADE USING FACTORY AUTHORISED PARTS.
● AT LEAST EVERY 6 MONTHS ,CHECK ALL BOLTS, SCREWS AND KNOBS TO BE SURE THEY ARE TIGHT.
● USE THIS PRODUCT FOR SEATING ONE PERSON AT A TIME ONLY.
WARNING
DO NOT USE THIS CHAIR AS A STEP LADDER.●
Please unzip and remove all the parts from within the base.
D
C
B
E
Please make sure the lips at the top of the leg are
located under the edge of the frame. If you have
difficulty locang the lips into the correct posion,
loosen the self tapping screws either side of the leg
fitment, which will release the frame from the
underside of the seat to create the small gap
needed to slide the lips under the frame. Connect
the leg and then re-ghten the screws.
A
Lips
Self tapping screw
A
Lips A×4
Adjustable feet