m-Dimension 1025 User manual

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Do not return this item to the store. Contact our friendly customer
service department with any . Replacements
for missing or damaged parts are normally shipped the same day!
Monday - Friday, 8am-5pm, ET. After business hours, leave a message.
We will return your call the next business day.
problems or comments
Thank you for purchasing our fine product!
This package contains all tools necessary for assembly.
#1025 Armless Tufted Chair
Page 1
#1025 Armless Tufted Chair
Assembly Instructions
WARNING: Failure to follow these directions and warnings can result in serious injury
and/or product damage.
!
!
!
!
!
!
!
Assistance is required to assemble this chair.
Never stand on the chair or use it as a ladder.
Do not tip the chair when seated.
Periodically re-tighten all bolts and legs.
Do not exceed 250 lbs. (113.4 kg) weight limit on the chair.
If any parts become missing, damaged or worn, discontinue use until they are replaced with identical parts.
Always seek assistance before moving furniture.

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Monday - Friday, 8am-5pm, ET.
Page 2
#1025 Armless Tufted Chair
Assembly Instructions
Step 1 - Remove all parts from their packaging and confirm that the quantities match those listed
above. If any parts are damaged or missing, please call our Customer Service Department at 1-866-
528-8364.
PARTS LIST
Part Drawing Part Name Qty.
A
Part Drawing Part Name Qty.
B
Chair Body
E
F
11
1 8
Left Front Leg
Right Back Leg
D
C
Right Front Leg
1
1
G
Allen
Wrench
1
Left Back Leg
Bolt with
Washers

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Monday - Friday, 8am-5pm, ET.
Page 3
#1025 Armless Tufted Chair
Assembly Instructions
Step 2 - Lay the Chair Body (Part A) on a flat surface like shown below. Pull the Velcro® attached dust
cover on the bottom of the seat back to expose the inner frame. Insert the Left Front Leg
(Part B), Right Front Leg (Part C), Left Back Leg (Part D) and Right Back Leg (Part E) into the
corresponding notches in the Chair Body frame. Align the bolt holes in the Legs with the bolt
holes in the Chair Body. Insert two Bolts with Washers (Part F) through each Leg and into the
Chair Body. Fully tighten all the bolts using the Allen Wrench (Part G). Do not over tighten the
bolts. Close the Velcro® attached dust cover on the bottom of the Seat.
Step 3 - With help, turn the chair upright.
Assembly is now complete.
AG
G
F
F
B
C
D
E