m-Dimension Chair 107 User manual

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Monday - Friday, 8am-5pm, ET.
Page 2
#107 Chair
Assembly Instructions
above. If any parts are damaged or missing, please call our Customer Service Department at 1-866-
528-8364.
PARTS LIST
Part
Drawing
Part Name Qty. Part
Drawing
Part Name Qty.
A
C
B
D
SEAT
CUSHION
BACK
CUSHION
FRONT
LEG PILLOW
1
1
RIGHT
1
LEFT
1
1
E
G
F
H
SHORT
BOLT
LONG
BOLT
DOWEL ALLEN
WRENCH
4
1
7
1
Step 2 - Insert the Dowel (Part G) into the top-
center hole in the back of the Seat Cushion (Part
A).
Step 4 - Insert one Short Bolt (Part F) into each of
the three holes at the rear of the Seat Cushion.
Thread the bolts clockwise by hand. Do not
tighten the Bolts at this time.
G - Dowel
Step 3 - Lay the Back Cushion (Part B) on a soft,
flat surface such as a carpeted floor and align the
dowel in the Seat Cushion with the top-center hole
in the Back Cushion.
F - Short Bolt
Step 1 - Remove all parts from their packaging and confirm that the quantities match those listed

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Monday - Friday, 8am-5pm, ET.
Page 3
#107 Chair
Assembly Instructions
Step 5 - Insert one Long Bolt (Part E) through each
of the four holes in the corner blocks located on the
underside of the Seat Cushion frame. Thread the
Long Bolts clockwise by hand.
E - Long Bolt
Step 7 - To install the Front Legs (Part C), match the Front Right Leg with the front right slot on
the Chair Seat. Insert the Front Right Leg into the notch in the frame of the Chair Seat.
Once inserted, slide the leg into position until the holes in the leg match the holes in the corner block.
Insert the Short Bolts (Part F) through the corner block and into the threaded inserts in the leg. Tighten
the Bolts using the Allen Wrench (Part H). Do not overtighten the Bolts. Repeat Step 7 to attach the
Left Leg.
C
Notch
Corner Block
Step 8 - Close the dust cover and with help, place the chair upright. Place the Pillow (Part D) upright
on the Chair Seat. Assembly is now complete.
Step 6 - Once all seven bolts have been hand
threaded, fully tighten them using the Allen Wrench
(Part H). Do not over tighten the Bolts.

Give us a chance to make it right.
TOLL FREE: 1-866-528-8364
Do not return this item to the store. Contact our friendly customer
service department with any . Replacements
for missing or damaged parts are normally shipped the same day!
Monday - Friday, 8am-5pm, ET. After business hours, leave a message.
We will return your call the next business day.
problems or comments
Thank you for purchasing our fine product!
This package contains all tools necessary for assembly.
#107 Chair
Page 1
#107 Chair
Assembly Instructions
WARNING: Failure to follow these directions and warnings can result in serious injury
and/or product damage.
!Assistance is required to assemble this chair.
!Never stand on the chair or use it as a ladder.
!
!
!
!
!
Do not tip the chair when seated.
Periodically re-tighten all bolts and legs.
Do not exceed 250 lbs. (113.4 kg) weight limit on the chair.
If any parts become missing, damaged or worn, discontinue use until they are replaced with identical parts.
Always seek assistance before moving furniture.