DREAMS LUGANO SINGLE BED User manual

1 of 4
LUGANO SINGLE BED
Assembly Instructions
NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that
the bed will be used in.
1. We suggest you spend a short time reading through this leaflet and then
follow the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the
assembly should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children’s reach.
In the unlikely event that this product has missing or damaged parts, please call
0870 3333 612 to obtain spares
Before you
Start, here
is some
helpful advice

2 of 4
Component parts and fittings contained in the box
PARTS Fittings
A
B
C
D
E
F
M6 Nut 6pcs
M6x35mm Bolt 6pcs
4MM Allen key 1pc
5MM Allen key 1pc
Spanner 1pc
M8x100mmBolt 4pcs
2 pieces
1 piece
2 pieces
2 pieces
1 piece

3 of 4
ASSEMBLY
1) Fix the wooden legs (4) onto the headboard
(1) & footboard (2) using bolt (F).
2) Loosen the bolts from the headboard (1) and
footboard (2).
NOTE: Merely loosen the bolts, do not take out.
1) Fit the side rail (3) to the head &
Footboard (1&2) slotting the pre-fitted
brackets together as shown.
STEP 1
STEP 2

4 of 4
ASSEMBLY
NOTE:Slats not supplied shown for
reference only.
Both slats on “step 3---step 4” can
be assembled to the bedstead. you
can to make a choice between the
two slats.
1) Carefully locate the slats frame onto the
bed.
2) Use bolt (A) and JCN nut (B) to fix the
slats frame onto the bed.
1) Carefully locate the slats frame onto the
bed.
2˅Use bolt (A) and JCN nut (B) to fix the
slats frame onto the bed.
STEP 3