Remove the two knobs on the rear cover and
unscrew the knob on the end of the freewheel
mode lever. Lift up carefully on the rear cover to
remove.Therearcoverwillstillbeconnectedtothe
scooterbythewhitetaillightconnectorcable.
Installthe seat post. Ensure that the seat post
isalignedsothatthetwoflanges with holes are
facingthe rear oftheproduct. Having these flanges
rotatedinto anyotherposition willresultin instability
intheseat.
Attach the two battery connectors to the
batteries (red to red and black to black).
Removeyour scooterfromits packaging.Raise
thetillerbypushingdownonthetillerlever,lifting
thetiller into place, then releasing the lever.
Replace the rear cover, making sure the tabs
onthebottomoftherearcoverfitintotheslots
inthescooter’s floorboard. Replace and tighten the
two knobs and the freewheel mode knob removed
in Step 2.
Frombehindtheproduct, lookingforward, insert
theseat bolt intoholeon the leftsideof the seat
post.Thisboltisalsoused to adjust the seat height.
Insertthe bolt as farintothehole as it willgo,making
sure that the bolt passes all the way through to the
holeon the opposite side. Install the washer andnut
andtighten them using the includedflatwrench.
Liftthe seatandpulltheswivel leverupatthe
sametime.Lowerthebottomoftheseatonto
theseat post. Releasethe lever,swivel theseat
and push downontheseat until it locksinplace.
1NOTE: Get help when placing the seat onto the
post to avoid scratching the cover shroud.
Insert the armrests into the attachment points
in the seat frame so that the armrests face
forward.
Please Read Before Operating!
For technical assistance, call toll free (866) 621-4933 or (800) 544-5155.
Quick Start Guide
Osprey
