Dual CS 455-1 User manual

CS 455-1 / CS 460
HiFi
Automatic-Turntable
Bedienungsanleitung
Operating Instructions
Notice d‘emploi

1
2
3
4
5
6 7
8
9
12
11
10
13 15 14 18 16 17

E N G L I S H

Instead of the factory-supplied pick-up cartridge any other
cartridge with standard half-inch mounting holes and a weight
between 3 and 10 grams can be installed.
– Remove the coloured signal leads carefully from the cartridge
pins with a pair of tweezers.
– Loosen the collar-lock 9behind the head shell. Carefully pull
the coloured signal leads out of the head shell. (Fig. 5). Install
the head shell in reverse order. Pay attention to the correct
colour coding
R = Red, right channel
RG = Green, right channel ground
L = White, left channel
LG = Blue, left channel ground
Adjusting after change of pick-up cartridge system
For the precise adjustment of the so-called stylus overhang push
the supplied mounting gauge into the head shell with cartridge.
The adjustment is correct if the stylus is flush with the V-shaped
recess in the gauge as viewed from above. When viewed from
the side the stylus should be seen within the rectangular recess
of the gauge (Fig. 7). Adjust the cartridge in the head shell until
the correct positions are achieved. Lastly, tighten the mounting
screws, put the head shell with cartridge back on the tone arm
and tighten the collar-lock 9.
ATTENTION!
During these mounting and adjustment procedures you must be
very careful not to damage the delicate stylus and cantilever by
uncontrolled and brisk movements.
Change of cartridge system
– Remove the coloured signal leads carefully from the cartridge
pins with a pair of tweezers.
– Unscrew the cartridge.
– Screw the new cartridge onto the head shell but do not
tighten. Attach the leads to the pins while observing the
correct coding.
Mounting or exchanging a pick-up cartridge system

Technische Daten
Meßwerte = typische Werte
Technical data
Measured values = typical values
Caractéristiques tech-
niques
valeurs mesurées = valeurs typiques
Riemenantrieb
elektronisch geregelter Gleich-
strommotor
Belt Drive
electronic-controlled DC motor
Entraînement à courrole
moteur à courant continu reglè par
électronique
Netzspannung
(Steckdosen-Netzgerät)
Mains voltage
(mains set)
Tensions secteur
(adapteur secteur)
230 V/50 Hz
115 V/60 Hz
Netzfrequenz Line frequency Fréquence secteur 50/60 Hz
Leistungsaufnahme Power requirement Concommation 1,5 W
Plattenteller-Drehzahlen
U/Min
Platter speeds
rpm
Vitesses du plateau
tr/mn
33, 45, 78
Gleichlaufschwankungen
DIN/WRMS
CS 455-1
CS 460
Wow and Flutter
DIN/WRMS
CS 455-1
CS 460
Tolérance de vitesse
DIN/WRMS
Ve
± 0,07/0,04 %
± 0,06/0,035 %
Störspannungsabstand
(DIN 45500)
Rumpel-Fremdspannungs-
abstand
Rumpel-Geräuschspannungs-
abstand
Signal-to-noise ratio
(DIN 45500)
Rumpel unweighted signal-to-
noise ration
Rumpel weighted signal-to-noise
ratio
Rapport signal/bruit
(DIN 45500)
Signal/tension extérieure de
ronflement
Signal/tension perturbatrice de
ronflement
ore
48 dB
72 dB
Effektive Tonarmlänge Effective tonearm lenght Longeur efficace du bras 211 mm
Kröpfungswinkel Offset angle Angle de coude 26°
Überhang Overhang Excédent 19,5 mm
Tangentialer
Spurfehlwinkel
Tangential tracking error Angle tangentiel de
I’erreur de piste
0,15°/cm Rad.
Magnet-Tonabnehmer
HiFi DIN 45500
rot R rechter Kanal
grün RG rechter Kanal
Masse
blau GL linker Kanal Masse
weiß L linker Kanal
Cartrige HiFi DIN 45500
red R right channel
green RG right channel ground
blue GL left channel ground
white L left channel
Cellule HiFi DIN 45500
rouge R canal droit
vert RG masse canal droit
bleu GL masse canal gauche
blanc L canal gauche
OMB 10
Diamantnadel für 33/45
elliptisch
Diamond stylus for 33/45
elliptical
Aiguille/diamant pour33/45
elliptique
DN 10
18x8 µm
Diamantnadel für 78
sphärisch
Diamond stylus for 78
conical
Aiguille/diamant pour 78
sphériques
DN 167
65 µm
Empfohlene Auflagekraft Tracking force Force d’appui 15 mN ± 2 mN
(1,5 ± 0,2 g)
Übertragungsbereich Frequency range Bande passante 20 Hz – 22 kHz
Übertragungsfaktor Output Facteur de transmission 4 mV/5 cms-1/1 kHz
Abtastfähigkeit (315 Hz) Tracking capability (315 Hz) Capacité de lecture (315 Hz) 80 µm
Tonabnehmergewicht Cartridge weight Poids de cellule 2,5 g
Gesamtkapazität
Tonarmleitung und Tonabneh-
merkabel
Total capacitance
Tonearm leads and audio-cables
Capacité totale
Câble du bras et câble de la cellule
~ 160 pF
Abmessungen (B x H x T) Dimensions (W x H x D) Dimensions (L x H x P) CS 455: 420 x 360 x119
CS 460: 430 x 365 x119

DUAL Phono GmbH
Feldbergstr. 11
78112 St. Georgen
Tel. [phone]
Fax [phone]
www.dual-phono.de
[email protected]