Dura Trel 11130 User manual

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020
SEAT ASSEMBLY
(Refer to Drawing 1)
Lay the two 48” seat rails on clean, flat surface with pilot holes facing up. Set the brackets over
pilot holes in rails, with the flanged side of the bracket toward center of seat. Fasten brackets to
seat rails with ¾” screws. Slide end caps over ends of seat, end caps will slide between bracket and
rails. You may apply household glue to inside of end cap if needed.
Place planter seat between two planter boxes by setting brackets over the edge of both planters.
If you encounter missing or defective parts, please contact manufacturer direct at
toll free # below.
#11130 PLANTER SEAT
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED
Drill with #2 Phillips Bit or
Phillips Screwdriver
Super or Crazy Glue (optional)

Dura-Trel, Inc. – PO Box 122, Sheboygan Falls, WI 53085 – Toll Free 877-258-6020
PACKING LIST
PARTS CONTAINED:
QTY. PART NO. PART DESCRIPTION
2 41555-48003W 1½ x 5½ x 48” SEAT RAIL (w/ wood inserts)
2 4TBCK-08752 8¾” BRACKET
2 5ECAP-11180
⅞x 1½ x 11⅛” END CAP
Hardware Bag Includes:
8 7HDWR-06034 ¾” SCREW
1 PLANTER SEAT INSTRUCTION
NOTE: Some parts may be packed inside of others.
If you encounter missing or defective parts, please contact manufacturer direct at toll free # below.
#11130 planter SEat