DV8 OFFROAD D-JP-180011-BK User manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
PRODUCT
INSTALLATION MANUAL
4WD SHIFT KNOB
07-18 JEEP JK WRANGLER
D-JP-180011-BK
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
- 2.5mm Allen Bit
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Novice
- 1 (you)
Little skill level required, you can
easily install it by yourself.
- .5 Hour
Time to install this should only
take about half an hour.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
855-680-9595
NEED HELP?

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 1 | Shift the vehicle out of 2wd
to provide room to remove the factory
shift knob.
STEP 2 | Grab the knob and pull /
twist upwards with force to remove the
factory shift knob.
Begin by unpacking all items and inspecting
for missing pieces or damage. If you have any
concerns, please contact the company the
product was purchased from. Extra hardware
may be included with the product.

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 3 | Remove the rubber grip from
the DV8 shifter and use a 2.5mm allen bit
to loosen the set screw.
Note: Do not remove completely, as there is no
need and it is very easy to lose.

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 4 | Slide the DV8 shift knob into
place and tighten the set screw using a
2.5mm allen bit.
STEP 5 | Replace the rubber grip to
the DV8 shift knob.
Then, move the shifter back into the 2wd
position.

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 6 | Congrats, you are nished
with the install of the 07-18 JK Wrangler
DV8 4WD Shift Knob!