DV8 OFFROAD OE PLUS SRBR-05 User manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
855-680-9595
NEED HELP?
PRODUCT
INSTALLATION MANUAL
OE PLUS SERIES STEPS
2021+ (2-DOOR) FORD BRONCO
SRBR-05
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
- 13, 16mm Socket
- 13mm Wrench
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Novice/Intermediate
- 2 people
Some skill level required.
Additional help will be needed for
this install
- 1 Hour
Time to install this should only
take about an hour
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 1
STEP 3
Begin by unpacking all items and
inspecting for missing pieces or
damage. If you have any concerns,
please contact the company the
product was purchased from.
With the side of the Bronco clear,
loosely secure the slider to the
pinch welds using the provided M8
hardware.
(Pictured on next page)
Note: Assistance is recommended to
prevent injury or damage to the product
and vehicle.
STEP 2
Remove any factory sliders, steps,
or rock rails if equipped since they
cannot be used with our steps.
Broncos with factory equipped
rock sliders will have brackets for
mounting on the underside of the
vehicle, these must be removed to
mount our steps.
(4) M10x30mm Bolts
(4) M10 Flat Washers
(4) M10 Split Washer
(8) M8x35 Bolts
(8) M8 Split Washers
(16) M8 Flat Washers
(8) M8 Nuts
Hardware Included:

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 4
STEP 5
With the slider loosely mounted
to the vehicle, loosely install the
provided M10 hardware into the
factory threaded holes.
Lift the slider into place where it is
even with the ground and tighten the
pinch weld both using a 13mm socket
and wrench.

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 6
STEP 7
Secure the remaining M10 hardware
using a 16mm socket.
Double check tment and all
hardware is secure.
Repeat steps for other side of the
vehicle.
Congrats! You are nished with the
install of the 21+ Ford Bronco 2-Door
OE Plus Series Steps.