DV8 OFFROAD SRBR-03 User manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
855-680-9595
NEED HELP?
PRODUCT
INSTALLATION MANUAL
PINCH WELD COVERS
2021+ Bronco
SRBR-03
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
- 10mm, 13mm Socket
- 4mm Allen Bit
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Novice/Intermediate
- 1 person (you)
Some skill level required. You
can easily install this by yourself,
however, additional help may be
useful.
- 1.5 Hour
Time to install this should only
take about an hour and a half.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 1
Begin by unpacking all items and
inspecting for missing pieces or
damage. If you have any concerns,
please contact the company the
product was purchased from.
STEP 2
Remove any factory sliders, steps, or
rock rails if equipped.
(5) M6x30
(4) M6 Flat Washers
(13) M8x25
(24) M8 Flat Washers
(12) M8 Serrated Nuts
Hardware Included:
STEP 3
Use a 10mm socket to remove
the bolts located on the pinch
weld covers towards the front
of the vehicle, directly behind
the front tire.

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 4
STEP 5
Place the front section of the covers
up to the pinch welds and secure
using the provided M6 and M8
hardware with a 10mm and 13mm
socket.
Note: The M6 hardware must be used
for the (2) front mounting holes.
Place the rear section of the covers up
to the pinch welds and secure using
the provided M8 hardware with a
13mm socket.

INSTALLATION MANUAL
855-680-9595
NEED HELP?
STEP 6
Double check all hardware is secure.
Congrats! You are nished with the
install of the 2021+ Ford Bronco
4-Door Pinch Weld Covers.