DV8 OFFROAD WINCH POCKET FAIRLEAD User manual

6400 SYCAMORE CANYON BLVD.
RIVERSIDE, CALIFORNIA 92507
855-680-9595
WWW.DV8OFFROAD.COM
PRODUCT
INSTALLATION MANUAL
WINCH POCKET FAIRLEAD
WBPF-01
TOOLS REQUIRED SKILL LEVEL TIME REQUIRED
- Snap Ring Pliers
- 5/16” Allen Bit
- 3/4” Wrench
Before you install this kit — Read and understand all
instructions, warnings, cautions, and notes contained in
this installation instruction guide. Consult your vehicle
owner’s manual for proper disconnection of electrical and
lifting of vehicle if required for installation of this product.
This install may require some technical skills and
knowledge of basic mechanical work. If you do not feel that
you are capable of performing this install please take this
product to a trained professional.
After reading this guide please contact us with any
questions or concerns before installing product.
Customer Service: 855-680-9595
DV8 Offroad is not responsible for any bodily injury or harm to you
or your vehicle as a result of an improper install.
Proper installation of this kit required knowledge of the factory
recommended procedures for removal and installation of original
equipment components. We recommend that the factory shop manual
and any special tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper knowledge of the
factory recommended procedures may affect the performance of these
components and the safety of the vehicle
• Always wear eye protection when operating power tools
Inspect all contents of this package to make sure product is not damaged
and all installation hardware has been included. If parts are missing from
kit, please be prepared to provide the following information
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
- Novice
- 1 (you)
Little skill level required, you can
easily install it by yourself.
- .5 Hour
Time to install this should only
take about half an hour.
WARNINGS/CAUTIONS BEFORE STARTING INSTALLATION
855-680-9595
NEED HELP?

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 1 | Pull the winch line through
the fairlead and secure the fairlead to the
bumper using the provided 1/2” hardware
with a 5/16” allen bit and 3/4” wrench.
Begin by unpacking all items and inspecting
for missing pieces or damage. If you have any
concens, please contact the company the
product was purhcased from. Extra hardware
may be included with the product.
- (2) 1/2”x1.5”
- (2) 1/2” Nylon Lock Nuts
- (2) 1/2” Flat Washer
HARDWARE INCLUDED

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 2 | Use snap ring pliers to
remove the snap ring to release the pin.
Tip: Due to the tension on the snap ring, it is
very easy to lose it during removal. Be careful
when removing, not to let it off the pliers until
you are ready.
STEP 3 | Slide the pin back into place
through the winch line and re-secure the
pin using the snap ring and snap ring
pliers.
Ensure snap ring is set into groove fully
on hook.

INSTALLATION MANUAL
NEED HELP? 855-680-9595
STEP 4 | Use the winch remote to
spool in the winch line and seat the hook.
STEP 5 | Congrats! You are nished
with the install of the DV8 Winch Pocket
Fairlead.