Dynojet POWER COMMANDER III User manual

i510-411 www.powercommander.com 2004-2007 Triumph Rocket III - PCIII USB - 1
2004-2007 Triumph Rocket III
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com
Parts List
1Power Commander
1USB Cable
1CD-ROM
1Installation Guide
1Power Adapter
2Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1O2 eliminator
1Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port

1 Remove the seat.
2Prop the fuel tank up using the
stock prop rod.
3Remove the right hand side
cover.
4Route the PCIII harness from
the right hand side of the bike
under the frame rail and towards
the front of the bike (Fig. A).
5Attach the ground wire from the
PCIII to the negative side of the
battery (Fig. B).
6Unplug the BLACK connector
from the throttle bodies to the
main wiring harness (Fig.
C). This connector is located
under the fuel tank towards the
front of the bike.
Fig. AFig. BFig. C
i510-411 www.powercommander.com 2004-2007 Triumph Rocket III - PCIII USB - 2
PCIII harness
PCIII harness
Ground wire from PCIII
Unplug this connector

10 Mount the PCIII unit to the side
of the relays and ECU using the
supplied velcro. The velcro may
not be needed as the side cover
will hold the PCIII in place.
11 Bolt the fuel tank back into posi-
tion.
12 Reinstall the side cover.
Note: The O2 eliminator allows you to
get the full potential out of the
bike and the Power Commander.
The stock bike has a closed loop
area that is controlled by the O2
sensor. Without the O2 elimina-
tor the fuel curve can NOT be
adjusted below 40% throttle or
3000rpm.
Fig. F
7Plug the connectors from the
PCIII in-line of the stock wiring
harness and throttle bodies
(Fig. D). Tuck the connectors
towards the front of the bike and
down as far as possible to clear
the fuel tank.
Fig. D
i510-411 www.powercommander.com 2004-2007 Triumph Rocket III - PCIII USB - 3
Stock connectors
PCIII connectors
8Unplug the connector from the
stock O2 sensor. This connec-
tion is under the right hand side
cover in front of the ECU
(Fig. E).
9Plug the O2 eliminator into the
stock wiring harness. The con-
nector from the O2 sensor does
NOT have to be plugged into
anything.
Fig. E
Unplug