Dynojet Power Commander III User manual

i234-411EX 2008 Kawasaki ZX14 - PCIII USB EX - 1
2008 KAWASAKI
ZX14
INSTALLATION INSTRUCTIONS
Dynojet Research • 2191 Mendenhall Drive • North Las Vegas, NV 89081 • [phone]
DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE:
WWW.POWERCOMMANDER.COM
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
PARTS LIST
quantity description
1 power commander EX
1USBcable
1cd-rom
1 installation guide
1poweradapter
2 power commander decal
2dynojetdecal
2 dual lock velcro strip
1 alcohol swab
2zipties USB port
expansion port

i234-411EX
2008 Kawasaki ZX14 - PCIII USB EX - 2
The ignition must be turned OFF before
installation.
1 Remove the left hand fairing and inner fairing.
2 Remove the bolts that hold the coolant reserve
bottle to the engine as shown in Figure A.
Temporarily let the bottle hang out of the way.
3 Unplug the stock connector from the throttle
bodies as shown in Figure B.
This is a brown connector located under the
throttle bodies.
4 Temporarily lay the PCIII USB EX next to the
gauge panel and route the PCIII USB EX
harness along the stock wiring harness to the
throttle body connection as shown in Figure C.
Figure AFigure BFigure C
remove bolts
unplug
connector
PCIII USB EX
harness

i234-411EX
2008 Kawasaki ZX14 - PCIII USB EX - 3
5 Attach the connectors from the PCIII USB EX
harness to the throttle bodies and stock wiring
harness connectors as shown in Figure D.
6 Attach the ground wire from the PCIII USB EX
to the frame using the stock upper bolt
holding the coolant reserve bottle to the frame
as shown in Figure E.
Verify the ground wire from the PCIII USB EX
is between the coolant bottle and the frame.
7 Reinstall the coolant reserve bottle.
8 Install the PCIII USB EX to the left hand ram air
tube. Use the supplied zip ties to secure the
PCIII USB EX harness to the stock wiring
harness. This will secure the PCIII USB EX in
place without needing to use the velcro.
9 Reinstall all body work.
10 Insert the cd provided into your computer’s
cd-rom drive.
11 Follow the on-screen instructions to install the
PCIII USB EX software.
Visit www.powercommander.com to
download software tutorials and the latest
maps.
Note: This bike uses a servo to hold the
throttle plate open during cold starts. Verify
the bike is up to operating temperature before
resetting the throttle position on the
PCII USB EX software.
Figure DFigure EFigure F
stock connector
stock
connector
PCIII USB EX
connectors
PCIII USB EX
ground wire
stock bolt
ignition module
ground wire
coolant reserve bottle
frame
zip tie