Dynojet POWER COMMANDER III User manual

i315-411 2003-2004 Suzuki GSXR 1000 - PCIII USB - 1
2003-2004 Suzuki GSXR 1000
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
1 Velcro®Strip
1 Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port

1 Remove the main seat and the
passenger seat.
2 Hold the front of the fuel tank
up using the prop rod located in
the trunk area.
3 Locate the connector from the
main wiring harness to the
injector rail and uplug this
connector (Fig. A).
NOTE: This connector is black in color.
4 Plug the connectors from the
PCIII in-line of the stock wiring
harness (Fig. B).
5 Route the PCIII wiring along the
inside of the frame towards the
battery.
6 Attach the ground wire from the
PCIII to the negative side of the
battery (Fig. C).
Fig. AFig. B
Fig. C
i315-411 www.powercommander.com 2003-2004 Suzuki GSXR 1000 - PCIII USB - 2
Unplug this connector
Ground wire from the PCIII.
View from L.H side
PCIII connectors
Stock connectors

7 Install the PCIII in the rear
section of the trunk using the
supplied velcro (Fig. D). Make
sure to clean both surfaces with
alcohol first.
8 Make sure all the wires are
routed properly.
9 Bolt down the fuel tank.
NOTE: When lowering the fuel tank make
sure the fuel line does not kink at
the frame support. If this hose does
kink the bike may not run properly.
10 Reinstall the main seat and the
passenger seat.
Fig. D
i315-411 www.powercommander.com 2003-2004 Suzuki GSXR 1000 - PCIII USB - 3