Eaton X10 DC User manual

+DC -DC IN 1 IN 2
10-60DC
SETTINGSTABLE
LOCATION
25-13926-E
Quick install guide
X10 DC
10-60vDC /10-30v AC
Figure 1
Figure 2
Figure 3
DC
JP1 JP2 JP3 JP4 JP5
10-60v
IMPORTANT MAKE SUREJUMPERS ARE CONFIGURED AS ABOVE
JP1 JP2 JP3 JP4 JP5
Stage 2 BS Fire Tone
Stage 2 1Hz Flash
(60 FPM -
Flash Per Minute)
Factory Default Setting
1 2 3 4
DUR3 DUR2 DUR1
SYNC
MODE
VOL
TONESTAGE1 TONESTAGE2,3,4 BCNST1/2/3-4
Stage 1 Tone
Advanced Settings
Max Volume
Standard Mode 3 Stage
Immediate Start
Time out Disabled
BS Fire Tone
Stage 2 BS Fire Tone
Stage 3 PFEER Toxic
Gas
Beacon Pattern
Stage 1 Off
Stage 2 1Hz Flash
(60 FPM - Flash per Minute)
Stage 3 Off
CAUTION!
ISOLATE POWER
Volume control
Tone selection - Stage 1
Tone selection - Stage 2/3/4
Beacon control
Mini & Midi Maxi
Only qualified personnel
may install, configureor
repairthis product.
www.acornfiresecurity.com
www.acornfiresecurity.com

Quick install guide
X10 DC
10-60v DC / 10-30vAC
0.55-0.65Nm
SETTINGS TABLE
LOCATION
25-13926- E
Figure 4
Figure 5
0.35-0.40Nm
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
ISOLATE POWER
CAUTION!
CLICK!
Default settings
SDR TONE
BEACON
SPL
Stage 1 BS Fire Tone
Stage 2 BS Fire Tone
Stage 3 PFEER Toxic Gas
Stage 1 O
Stage 2 1Hz Flash
(60FPM- Flash Per Minute)
Stage 3 O
Max
Stage Polarity + Supply
Only qualified personnel
may install, configure
or repair this product.
www.acornfiresecurity.com
www.acornfiresecurity.com