Eaton X10 User manual

230 115
SETTINGS TABLE
LOCATION
25-13925-E
1 2 3 4
DUR3 DUR2 DUR1
SYNC
MODE
VOL
TONESTAGE1 TONESTAGE2,3,4 BCNST1/2/3-4
Figure 1 Figure 4
Figure 2
Figure 3
Quick install guide
X10 AC
115V/230V AC
Advanced Settings Stage 1 Tone Beacon Pattern
Max Volume
Standard Mode 3 Stage
Immediate Start
Time out Disabled
BS Fire Tone
Stage 2 BS Fire Tone
Stage 3 PFEER Toxic
Gas
Stage 1 Off
Stage 2 1Hz Flash
(60 FPM - Flash per Minute)
Stage 3 Off
Factory Default Setting
Stage 2 BS Fire Tone
Stage 2 1Hz Flash
(60 FPM -
Flash Per Minute)
CAUTION!
ISOLATE POWER
Figure 5
Volume control
Beacon control
Tone selection - Stage 1
Tone selection - Stage 2/3/4
Mini & Midi Maxi
Only qualified personnel
may install, configure
or repair this product.

6
0.55-0.65Nm
0.35-0.40Nm
SETTINGS TABLE
LOCATION
Default settings
SDR TONE
BEACON
SPL
Manual:
For more information on how to further adjust
and setup the Eaton X10 please refer to the
manual:
www.eaton.com/manuals/x10
Contact:
Technical support
Tel: [phone]
Email: [email protected]
Eaton Electrical Products
Llantarnam Park,
Cwmbran
NP44 3AW,
United Kingdom
© 2017 Eaton
All Rights Reserved
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
Figure 6
Figure 7
25-13925-E
Quick install guide
X10 AC
115V/230V AC
Stage 1 BS Fire Tone
Stage 2 BS Fire Tone
Stage 3 PFEER Toxic Gas
Stage 1 O
Stage 2 1Hz Flash
(60FPM - Flash Per Minute)
Stage 3 O
Max
ISOLATE POWER
CAUTION!
CLICK!
Only qualified personnel
may install, configure
or repair this product.