EtherWAN EX46900A Series User manual

W70G-EX469V2Q1 Page 1
Installation Guide
EX46900A Series | Hardened Unmanaged PoE Gigabit Ethernet Switch
Copyright 2022 EtherWAN Systems, Inc. All Rights Reserved 01/03/2023
1Unpacking
Open the carton and unpack the items. Your package
should include:
▪One EX46900A Switch
If any items are missing or damaged, notify your
EtherWAN representative. If possible, save the carton
and packing material in case you need to ship or store
the switch in the future.
2Equipment Needed
▪Category 5 or better cable for RJ-45 ports
▪Appropriate SFP modules for SFP ports
3Select a Location
▪Installation: DIN rail. Place the device on the DIN
rail from above using the slot. Push the front of
the device toward the mounting surface until it
audibly snaps into place.
▪Choose a dry area with ambient temperature
between -40°C to 75°C (-40°F to 167°F).
▪Keep away from heat sources, sunlight, warm air
exhausts, hot-air vents, and heaters.
▪Be sure there is adequate airflow.
4Connect to the Data Ports
Depending on the model, your switch can have the
following ports:
▪10/100/1000BASE-T: 8 PoE ports
▪1000BASE Fiber: 2 ports (Optional)
5Connect Power
Connect the supply voltage to start up the device via
the terminal block. Power consumption is 11.2 watts
without PoE. PoE budget is 120 watts, 30 watts per
port.
Terminal Block
The switch provides two power inputs on an 18-57VDC
terminal block. Only one power input is required to
operate the switch.
Pin
State
Description
Power 1
+
18-57VDC
-
Power Ground
Power 2
+
18-57VDC
-
Power Ground
Earth Terminal
Relay Output Rating
0.5A @ 48VDC
Relay Output
The relay output can be connected to an alarm
signaling device. Current is 0.5A @48VAC.

W70G-EX469V2Q1 Page 2
Installation Guide
EX46900A Series | Hardened Unmanaged PoE Gigabit Ethernet Switch
Copyright 2022 EtherWAN Systems, Inc. All Rights Reserved 01/03/2023
6LED Indicators
LED
State
Description
Power 1, 2
(Green)
On
Switch is powered ON
correctly
Off
Switch is not receiving power
Alarm (Red)
On
Relay alarm on
Off
Relay alarm off
Link/Act
10/100(Green)
1000 (Amber)
On
Valid network connection
established
Off
No link
Blinking
Transmitting or receiving
data
PoE (Amber)
On
Powered Device is
connected
Off
Powered Device is
disconnected
Blinking
Device powered at 30 Watts
Power-Up Sequence
When the switch is powered up:
▪All Link/ACT LEDs blink momentarily.
▪The Power 1, 2 LEDs light up and stay lit.
▪LEDs for every port connected to a device will
flash, as the switch conducts a brief Power On Self-
Test (POST).
7DIP Switch Settings
Manufacturer information:
EtherWAN Systems, Inc.
33F, No. 93, Sec. 1, Xintai 5th Rd., Xizhi Dist., New
Taipei City, 221 Taiwan
DIP No.
On
Off
1~10
Port 1~10 Alarm
Enable
Port 1~10 Alarm
Disable
11~12
N/A
N/A
The full product manual can be downloaded from:
www.etherwan.com