ETI 801-590 User manual

Non-contact
FOREHEAD THERMOMETER
Measuring forehead temperatures
Quick, easy, and reliable!
Power on device
1
Point at centre of forehead 4 cm away
2
Press and hold START for one second - a single
beep tells you it’s done
3
The non-contact forehead thermometer is pre-set to forehead
mode and to display temperature in Celsius. Three short beeps
followed by one long beep while taking a forehead reading
means that the temperature exceeded 37.5 °C (99.5 °F).
Please wait two seconds between measurements.
ELECTRONIC TEMPERATURE INSTRUMENTS LTD
Worthing • West Sussex • BN14 8HQ
01903 202151 • [e-mail] • etiltd.com

Functions
Power off device – Device will auto-off after 60 seconds
to save battery life. Or, press and hold Power button for
about ve seconds. ‘Off’ will ash before powering off.
View readings – With device turned on, press Power
button momentarily to see the last reading, which is
reading number one. Each subsequent press of the
Power button will show up to 25 readings in order. The
reading number will ash before displaying the value.
Mute – With device turned on, press and hold Power
button for three seconds until speaker icon ashes, then
release. Repeat steps to unmute.
Change to surface mode – With device turned on,
press and hold Power button, then press Start to toggle
between modes. Device will automatically return to
forehead mode after powered off and back on again.
Change from °C to °F – Default unit is °C. With device
turned off, press and hold Start and the Power button
simultaneously for three seconds. Units will change.
ELECTRONIC TEMPERATURE INSTRUMENTS LTD
Worthing • West Sussex • BN14 8HQ
01903 202151 • [e-mail] • etiltd.com
For guarantee, service, and technical assistance, please
contact our technical sales ofce on 01903 202151 or
email [e-mail]
Cautions
. Forehead should be clean, dry, and unobstructed
before taking readings.
. Non-contact thermometer is not waterproof. Avoid
wet areas and splashes.
. Do not expose device to temperatures above 38 °C
(100 °F) or below 10 °C (50 °F).
. Replace batteries when battery icon ashes.
. Store device at room temperature where readings
will be taken for best results.
. Avoid drops, bumps, and rough handling that could
damage device.
. Sensor lens area is the most delicate part; keep clean
and free from debris.
. Consult user manual before cleaning lens.