INSTRUMENT OPERATION - The
instrument will turn on once the battery is
installed. Please note: This product cannot
be placed within the fridge or freezer.
Place the probe within the fridge or freezer
using the sucker or fixing provided. The
instrument reading may take a few seconds
to stabilise. The probe will measure the
temperature of the fridge or freezer and
'FRIDGE' will be shown in the display. To
change the display to measure the room
temperature press the PROBE button and
'ROOM' will be displayed.
TEMPERATURE ALARM SETTING - FRIDGE/
FREEZER ONLY - To set the audible alarm,
press and hold the ALARM SET button,
the high alarm temperature will flash in
the display. To set the high alarm, press or
hold the red button on the back of the unit
to adjust the temperature. To set the low
alarm press the ALARM SET button again,
and press or hold the red button to adjust
the temperature. Press the ALARM SET
button to confirm. To turn on/off the alarm
press the ALARM SET button and 'AL' will be
displayed. The audible alarm will only sound
when the temperature had been exceeded
for 5 seconds, and again every 55 seconds
thereafter, 'AL' will also flash in the display.
Please note: This alarm only works on the
fridge/freezer probe.
MAX/MIN - Press the MAX/MIN button
to display the maximum reading (MAX
displayed). Press the MAX/MIN button again
to display the minimum reading (MIN
displayed). Press MAX/MIN button again to
return to normal readings. Hold MAX/MIN
for three seconds to reset minimum and
maximum temperature memory.
Please note: Max/Min readings are not
saved so removal of the battery will clear the
max/min readings.
°C/°F FUNCTION - Press the red button
on the back of the instrument to switch
between Centigrade and Fahrenheit.
BATTERY REPLACEMENT - The battery will
need to be replaced when the instrument
display dims. Replace the battery with a
3 volt lithium CR2032 coin cell. The battery is
located under the battery cover on the back
of the instrument.
EMC/RFI - Instrument performance may be
affected if operated within a high frequency
radio field, such as near a mobile phone, or
if subjected to an electrostatic shock.
GUARANTEE - This instrument carries a
one-year guarantee against defects in either
components or workmanship. During this
period, products that prove to be defective
will, at the discretion of ETI, be either
repaired or replaced without charge. This
guarantee does not apply to sensors/probes,
where a six-month period is offered. The
product guarantee does not cover damage
caused by fair wear and tear, abnormal
storage conditions, incorrect use, accidental
misuse, abuse, neglect, misapplication
or modification. Full details of liability are
available within ETI’s Terms & Conditions
of Sale at etiltd.com/terms. In line with
our policy of continuous development, we
reserve the right to amend our product
specification without prior notice.
