Euroscreen Vision Edgeless User manual

1
Vision Edgeless
Made in Sweden
02 jan. 2020, 08:01

2
Thank you for choosing a Euroscreen®to be part of your AV
installation. We hope it will bring you many hours of entertainment and/or
education depending on your preference. Please read through the
manual completely before installation and usage.
Tack för att ni valt en Euroscreen® som en del i er AV-installation. Vi
hoppas den kan ge er många timmar av underhållning och/eller
utbildning, beroende på aktivitet. Läs igenom hela manualen innan
installation och användning.

3
Edgeless bracket / Edgelesskonsol
Overview / Översikt
Case / Kassett
A ( 0,40 : 1 )
A
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
niclas.bexelius 2018-12-13
DWG NO
VE - WrapAround
TITLE
SIZE
D
SCALE
REV
1 : 5
52
52
76
115
g 1
A ( 0,40 : 1 )
A
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
SHEET 1 OF 1
DRAWN
CHECKED
QA
MFG
APPROVED
niclas.bexelius 2018-12-13
DWG NO
VE - WrapAround
TITLE
SIZE
D
SCALE
REV
1 : 5
52
52
76
115
g 2

4
g 3
UK: insert corner pieces into the frame pie-
ces. Remember to add the squared nuts into
their slot before assembling all the corners.
There should be two nuts for each bracket
(in total 4pcs) in the top extrusion. If there is a
center support there shall be one extra nut in
both the top and bottom extrusions.
Lock and tighten the corners (g 4).
Attach the brackets evenly on the top piece
to match the fastening points for the brackets
mounted on the wall (g 5).
SE: För in hörndelarna i ramprolerna. kom
ihåg att föra in fyrkantsmuttrarna i sitt spår
innan prolerna sätts ihop. Där skall vara
2st muttrar per konsol (totalt 4st) i den övre
ramdelen.
Om det skall monteras ett mittstag så behövs
det en extra mutter i både den övre och den
nedre prolen.
Skruva åt hörnen (g 4).
Fäst konsolerna jämnt fördelat på toppro-
len så att de passar med fästpunkterna för
konsolerna som skall skruvas fast på väggen
(g 5).
g 4
g 5
Overview / Översikt

5
g 9
g 8
UK: OPTIONAL
Attach center support in top and bottom (g
6).
Unroll the screensurface, viewing side down,
on a clean and smooth surface. Put frame
carefully on top. Frame corners shall reach
surface edges (g 7). Slide hook-
extrusions onto the screen surface (g 8).
Fasten hooks inte the groove (see g 9).
SE: OPTION
Fäst mittstaget i både topp och botten (g 6).
Rulla ut dukmaterialet med bildsidan nedåt
på en ren och slät yta. Lägg ramen försiktigt
ovanpå. Hörnspetsarna skall nå ut till duk-
kanten (se g 7). För på haklister runt om (g
8).
Fäst haklisterna i spåret (se g 9).
g 6
g 7

6
EN: Add bottom distance piece (see g 10).
SE: Montera den nedre distansen (se g 10).
g 10

7
115mm
EN: Hang the frame onto the wall
so that the brackets on the wall
and the frame interlock (g 12).
SE: Häng ramen på väggen så att
fästena på vägg och ram hakar i
varandra (g 12).
g 12
Wall bracket / Väggkonsol
g 11
Wall mount / Väggmontering
EN: USE FASTENERS INTENDED FOR THE
ACTUAL SURFACE. Try to level them up as
good as possible, using spirit level or laser
guide (g 11).
Sideways spacing isn’t crucial as they can
slide sideways but we recommend that you try
to even them out along the width.
Please note that center of the screw is
115mm from top edge of screen (g 12).
SE: ANVÄND FÖR UNDERLAGET AVSEDD SKRUV.
Försök att linjera de bägge konsolerna så horisontellt
som möjligt med hjälp av vattenpass eller lasermätare
(g 11).
Exakt positionering i sidled är inte nödvändig då ramen
kan glida på konsolerna men vi rekommenderar att
konsolerna förselas ut över bredden.
Notera att skruvhålet hamnar 115mm under överkant
dukyta (g 12).

8
REACH
The new EU chemicals legislation
Conformity of regulations
Draper Europe AB manufactures AV equipment within the brand Euroscreen®. These products are
controlled and certied by the below listed regulations.
REACH
Registration, evaluation, authorisation and limitation of chemicals. Regulation (EC) No 1907/2006 of the
European Parliament and of the European Council concerning the Registration, Evaluation, Authorisation and
Restriction of Chemicals (REACH).
All screen surfaces of Euroscreen®projection screens are approved by the REACH regulation.
ECHA
European Chemicals Agency (ECHA) gathers information on the properties of manufacturers and importers
chemical substances, which will allow their safe handling, and to register the information in a central
database.
Euroscreen®projection screens are printed with colours containing the following components:
CAS 1333-86-4, CAS 112-36-7, CAS 96-48-0, CAS 143-24-8, CAS 1559-34-8, CAS 2687-91-4,
CAS 111-90-0, CAS 34590-94-8 and CAS 126-86-3. These are all approved by ECHA.
RoHS
Restriction of Hazardous Substances Directive (RoHS) directive restricts the use of six hazardous materials in
the manufacture of various types of electronic and electrical equipment.
All electrical devises used in Euroscreen®products are RoHS certied.
WEEE
The Waste Electrical and Electronic Equipment Directive (WEEE Directive) is the European Community
directive 2002/96/EC on waste electrical and electronic equipment (WEEE) which, together with the RoHS
Directive 2002/95/EC, setting collection, recycling and recovery targets for all types of electrical goods.
Applicable Euroscreen®products are labeled with the WEEE symbol.
FR2000
FR2000 is an integrated management system for quality, environment, competence enhancement, health
and safety. This systems is derived from; ISO 9001, ISO 14001,SS 62 40 70, the Swedish work environment
authority regarding systematic environmental progress, and the Swedish rescue services agency regarding
systematic re safety, SRVFS 2004:3.
Draper Europe AB is certied by FR2000 since 2010.
FTI
Producers responsibilty for recycling of packaging material is regulated by SFS 2006:1273. The recycling
process of packaging material is handled for its members by a central organization called FTI.
Draper Europe AB is a member of FTI.
Declaration of Conformity
Draper Europe conrms that Euroscreen®Electric meets Low Voltage Directive 2006/95/EG &
EMC Directive 2004/108/EC. This is a EN61140 Class I product with internal separation instead of protective
conductor (EN61140 7.2.2 Note 2).
Euroscreens® are CE-approved.
Draper Europe AB / Västervallvägen 6 / 302 50 Halmstad
Tel: [phone] / Fax: [phone]