Fisher-Price 77855 User manual

w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
Spiral Speedway
77855
Instructions
Please keep this instruction sheet for future reference,
as it contains important information.
Requires two “AA” batteries (included).
Adult assembly is required.
Tool required for battery replacement:
Phillips screwdriver (not included).

• Make sure the areas where the labels will
be applied are clean and dry. Apply the
labels as shown in the illustration above.
• For best results, do not attempt to apply
a label more than once.
2
Press to
Start!
• Place the cars in the starting gate.
• Press down on the back of the starting gate
to hear engine “revving” sounds.
• Press down on starting gate pedal to start
the race and to hear engine “racing” sounds.
• Store the cars in the slots on the base of
the speedway.
Carry Handle
2
1
4
3
Carry Handle
•“Snap” the carry handle into the top of
the speedway.
• Insert the checkered flag into the hole in
the base of the speedway.
Checkered Flag
Hole
Checkered
Flag
Pedal
Starting Gate
Assembly
Decoration Let
’ s Race...
Storage
Press for Revving
Sounds

3
For best performance, we recommend
replacing the batteries that came with this
toy with two, new “AA” alkaline batteries.
1.5V x 2
“AA” (LR6)
SHOWN ACTUAL SIZE
• Locate the battery compartment on the
underside of starting gate.
• Loosen the screw in the battery compart-
ment door with a Phillips screwdriver
and remove the door.Throw away the
exhausted batteries.
• Remove the exhausted batteries from the
battery compartment. Properly discard the
used batteries.
• Insert two, new, “AA” (LR6) alkaline
batteries.
Hint: We recommend the use of alkaline
batteries for longest battery life.
• Replace the battery compartment door
and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• When sounds from this toy become faint
or stop, it’s time for an adult to replace
the batteries!
+
-
Battery Compartment
Batteries may leak fluids that can cause a
chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated on the battery
compartment door.
• Remove batteries during long periods of
non-use. Always remove exhausted
batteries from the toy. Dispose of batteries
safely. Do not dispose of batteries in a fire.
The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
toy before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Replacement Battery Safety
Information

FCC Note
(United States Only)
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations,
toll-free at 1-800-432-5437, 8 AM - 6 PM EST
Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment,
please call 1-800-382-7470. Or, write to:
Fisher-Price®Consumer Relations,
636 Girard Avenue, East Aurora,
New York 14052.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in Mexico 77855pr-0921
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential installa-
tion. This equipment generates, uses and
can radiate radio frequency energy and, if
not installed and used in accordance with
the instructions, may cause harmful inter-
ference to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
For countries outside the United States:
CANADA Questions? 1-800-567-7724. Mattel Canada Inc.,
6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
GREAT BRITAIN Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND 16-18 William Pickering Drive,
Albany 1331, Auckland.
ASIA Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.
• Wipe this toy with a clean cloth dampened
with a mild soap and water solution. Do not
immerse this toy.
• For best performance we recommend that
you clean the track periodically with a soft
dry cloth.
Care
Consumer Information