Furniture Solutions Dracula Home Office Chair User manual

Assembly Instuction
Dracula Home Office Chair
Furniture
Solutions
Solutions
1. Fit Wheels: Line up shaft of wheel (1) with
hole in Star base (2) If you have at a slight
angle with split washer flat on one side it
will slide in easier.
2. Fit Gas Lift: Have gas lift (3) upright as
indicated in drawing slide into hole, no need
to apply excessive force, Place dust cover
(4) over gas lift as indicated in diagram.
1. Fit Release Mechanism: Place seat (7) upside
down on a clean surface, identify front from
back of seat, place release mechanism with
arrow pointing to front of seat. Then take bolt
(9) and by hand insert into holes as indicated
in diagram only tighten 2-3 turns till all blots
fitted, once all seated tighten with allen key
(11) till firm DO NOT OVERTIGHTEN.

Operating Instuction
To set chair to your unique body shape & comfort adjust tilt action tension
1. Tilt action tension when operating tilt mechanism you are able to set rate of release by winding
tighter to decrease rate of release or loosen to increase rate of release. Note if to loose release may
happen too fast and you may cause damage to yourself or chair by falling out back of chair.
Too operate tilt mechanism: While in seated in a neutral position (weight not forward or back) pull black
trigger outwards from side of chair, once released you may recline backrest. To lock mechanism return
chair to neutral position and push black handle inwards this will lock reclining mechanism.
Maintence
With use bolts may loosen please ensure you check bolts on a regular bases, this will ensure safety & longer life for chair
Please see base of chair for fabric care instruction
Made In China
Imported By Furniture Solutions (Aust) Pty Ltd
3. Fitting Arms: Identify left from right see diagram holes
are in the back arms. With help of another person place seat
and back on side together, take arm and place over holes in
seat and back (6) by hand start bolt (10) in thread turn 2-3
times till seated in thread repeat for all bolts, once done
tighten all bolts till firm DO NOT OVERTIGHTEN.
4. Fitting Cover Caps: As indicated in diagram place cover
caps (12) in holes as indicated in diagram repeat till all hole
covered in arms.
5. Fitting seat & back to base: With help of another person
lift seat & back into position over base then slot top of gas
lift into hole of release mechanism, ensure it is seated
squarely, then place chair on to a flat surface. To make sure
seat is firmly attached before operating release mechanism,
sit in seat of chair, this action will squeeze gas lift into seat
release mechanism, once done press release handle to make
it rise and fall. Ready for use.