FURNITUREBOX TORINO TABLE User manual

TORINO TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/torino
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to avoid bumps or scratches.
First, connect leg [3] to large leg piece [4] - make sure you select the
correct small leg piece to start with, here - they are in labelled boxes.
Connect using wooden dowels [C] and threaded rod {I] followed by
Washer {D} then Nut {B} and tighten with spanner [G].
Pop stickers [J] over the holes on the other side of leg piece [4], as per
diagram.
Then, insert wooden dowels [C] and threaded rods {I] into the holes
on leg piece [4] ready for the next leg to be attached.

www.furniturebox.co.uk
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Carefully, and with help, ip your table correct side up, so it sits
on its legs.
Next, carefully align the table top so that the metal discs align
with the holes in the tops of leg ;pieces [4] and [3].
Fix table top to table by inserting threaded rod [A] into the
holes in the leg pieces and screwing into the metal discs of the
table top. Follow threaded rod [A] with washer [D] then nut [B]
and tighten with spanner [G].
Ensure each metal disc of the table top is securely xed to the
leg pieces.
STEP 2
Attach leg piece [2] to
leg piece [4]. Tighten
and secure into place by
inserting threaded bolt
[I] into holes indicated
on diagram, followed by
washer [D], then part [F]
and then nut [B]. Tighten
with wrench [H].
Attach the feet [E] to the
bottom on leg pieces [4]
and [2].