GIRA
Info Powernet Switchactuator 2fold/4fold
Installation Instructions
Powernet Switchactuator 2fold/4fold 03/99 Page: 1 of 3
Powernet Switchactuator 2fold Art. Nr.: 0430 00
Powernet Switchactuator 4fold Art. Nr.: 0433 00
456
123A1
A2
N
L
µ
NN L L
c
d
e
50 Hz
230 V AC~
10 11 12
789A3
A4
N
L
µ
NN L L
c
d
e
50 Hz
230 V AC~
456
123A1
A2
µ
System Information
This device is a product of the GIRA-Powernet ®
EIB system and complies with EIBA directives.
Detailed technical knowledge obtained in instabus or
GIRA-Powernet ®EIB training courses is a pre-
requisite to proper understanding.
The functionality of this device depends upon the
software. Detailed information on loadable software
and attainable functionality may be taken from the
manufacturer’s ETS2 product database as well as
from the GIRA-Powernet ®EIB controller database.
Planning, installation and commissioning of the unit
is done by means of the ETS2 software, Ver. 1.1 or
later, as well as by the GIRA-Powernet ®EIB con-
troller.
Function
The Switchactuator allows two (or, respectively,
four) groups of loads to be switched independent of
each other.
Connection
Establish electrical connection as shown in the
opposite illustration.
Where:
cGIRA-Powernet
® EIB connection.
dProgramming key.
eProgramming LED
The connection of different external leads to the
channels is admissible.
Indications of danger
Caution! The installation and assembly of
electrical equipment may be carried out only by
a skilled person. Do not connect any loads/types
of load other than specified.
Subject to change without notice.
