GLITZHOME OFFICE CHAIR 1009202149 User manual

Assembly Instruction
OFFICE CHAIR

1
PRE-ASSEMBLY PREPARATION
PARTS LIST
BACK (A) SEAT PLATE (D)SEAT (B) ARMREST (C)
Qty: 1 Qty: 1 Qty: 2 Qty: 1
Qty: 2 Qty: 2
ALLEN BOLT (K)
Qty: 4Qty: 4
HARDWARE LIST
ALLEN BOLT (J)ALLEN BOLT (H) ALLEN BOLT (I)
Qty: 1
ALLEN WRENCH (M)
Qty: 4
CAP (L)
5/16* X 1” 5/16 X 1-1/2” M8 X 55MM5/16 X 1-1/4”
BASE (F)
Qty: 1
GAS LIFT (E)
Qty: 1
WHEEL (G)
Qty: 5
•CAUTION: Assembly will require at least 2 adults. DO NOT use power tools.
Please inspect all items BEFORE assembly. If for any reason you need to return this item, please kindly
return it in it's original packaging.
•WARNING!
1. DO NOT let any sharp objects touch or rub the surface of the product.
2. When assembling, do not let children play around the working area.
3. DO NOT tighten all bolts and screws completely until the entire unit has been assembled and set up.
4. DO NOT USE if this product become damaged, and/or components are broken or missing.
•
MAINTENANCE: Please periodically check all fittings and re-tighten as necessary.
CARE AND CLEANING: DO NOT scratch or chip the finish. DO NOT use abrasive chemicals for cleaning.
Clean with mild soap on a soft rag. Rinse and dry thoroughly.
•

2
E
F
G
STEP 2
Attach the Seat Plate (D) to the Seat (B) by using Allen Bolt (I) and Allen Bolt (H) and
Allen Wrench(M).
STEP 1
Insert the Gas Lift (E) to the Five-jaw Base (F) , then snap in the Wheels (G) to the
bottom of Base as shown in below diagram.
B
I
M
H
D

3
J M
STEP 3
Attach the Back (A) to the Seat (B) by using Allen Bolt (J) and Allen Wrench (M).
STEP 4
Insert the Gas Lift to the Seat Plate as shown in below diagram.
FRONT
A

4
STEP 6
STEP 5
C
K
M
L
Press the Plastic Cap (L) into the holes of armrest to cover bolts and sit down on Seat Cushion.
Sitting on the Seat Cushion applies even pressure on the Gas lift and Star Base and ensure
them in place.
Attach the Armrest (C) to the back and seat by using Allen Bolt (K) and Allen Wrench (M) as
shown in below diagram.

STEP 7
5
After initial assembly, the product may acclimate to its new environment. Please ensure all
screws are still securely tightened.