GLITZHOME 5120522 User manual

Assembly Instruction
OFFICE CHAIR / DESK CHAIR

1
M6 x 25MM M6 x 30MM
PRE-ASSEMBLY PREPARATION
•CARE AND CLEANING: DO NOT scratch or chip the finish. DO NOT use abrasive chemicals for cleaning.
•
•
MAINTENANCE: Check bolts/screws periodically and tighten them if necessary.•
WARNING: DO NOT USE if this product become damaged, and/or components are broken or missing.
REMINDER: DO NOT fully tighten all bolts until assembly is completely finished.
PARTS LIST
BACKREST (A) RIGHT ARMREST (D)SEAT (B) LEFT ARMREST (C)
Qty: 1 Qty: 1
GAS LIFT (F)
Qty: 1
Qty: 1 Qty: 1
SEAT PLATE (E)
Qty: 1
Qty: 6 Qty: 2
BASE (G) WHEEL (H)
Qty: 1 Qty: 5
Qty: 4
HARDWARE LIST
LONG BOLT (K)
Qty: 1
ALLEN WRENCH (L)SHORT BOLT (I)
M6 x 20MM
MEDIUM BOLT (J)

2
B
B
D
A
L
K
C
L
J
E
STEP 2
Attach the Left Armrest (C) and Right Armrest (D) to the Seat (B) by using Long Bolt (K)
and Allen Wrench (L). Connect the Backrest (A) and Seat (B) by using Medium Bolt (J)
and Short Bolt (I) .
STEP 1
Attach the Seat Plate (E) to the Seat (B) by using Short Bolt (I) and Allen Wrench(L).
L
I
L
K
I
L

3
F
G
H
STEP 3
Insert the Gas Lift (F) to the Base (G) , and snap in the Wheels (H) as shown below.
STEP 4
Insert the Gas Lift (F) to the Seat Plate (E) as shown below.
After initial assembly,the product may acclimate to its new environment. Please unsure all
screws are still securely tightened.
Warning!
Please remove the
plastic cap before
assembly.
E
F