Goldmedal Citation User manual

Part No. 67861EX
Citation
Models #2001EX, 2001STX, 2001BNX
Instruction Manual
Cincinnati, OH 45241-4807 USA

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
2
SAFETY PRECAUTIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
DANGER
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment
will void the warranty and may cause a dangerous condition. This appliance
is not intended to be operated by means of an external timer or separate
remote-control system. NEVER make alterations to this equipment. Read the
Installation, Operating, and Maintenance Instructions thoroughly before
installing, servicing, or operating this equipment.
014_020416
WARNING
To avoid burns, DO NOT touch the kettle or any heated surface.
DO NOT place or leave objects in contact with heated surfaces.
013_092414
WARNING
ALWAYS wear safety glasses when servicing this equipment.
010_010914
WARNING
No user serviceable parts inside. Refer servicing to qualified service
personnel.
011_051514
WARNING
Read and understand operator’s manual and all other safety instructions
before using this equipment. To order copies of the operator’s manual go to
gmpopcorn.com or write to Gold Medal Products Co., 10700 Medallion Drive,
Cincinnati, OH 45241 USA 1-(800)-543-0862
022_060215

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
3
SAFETY PRECAUTIONS (CONTINUED)
WARNING
DO NOT allow direct contact of this equipment by the public when used in
food service locations. Only personnel trained and experienced in the
equipment operation may operate this equipment.
Carefully read all instructions before operation.
012_010914
WARNING
This machine is NOT to be operated by minors.
007_010914
Note: Improvements are always being made to Gold Medal’s equipment. This information may
not be the latest available for your purposes. It is critical that
you call Gold Medal’s Technical Service Department at -800-543-0862 for any
questions about your machine operations, replacement parts, or any service questions.
(Gold Medal Products Co. does not assume any liability for injury due
to careless handling and/or reckless operation of this equipment.)

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
4
Forward
This manual covers the 16oz. Citation Popcorn Machine, model number 2001EX, 2001BNX, and 2001STX.
Installation Instructions
Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during transit.
Damage claims should be filed immediately with the transportation company. Gold Medal is not
responsible for damage that occurs in transit.
Setup:
Your new Citation Popcorn Machine is completely assembled and tested at the factory.
Remove all packing material and tape before starting operation.
Electrical Requirements:
The following power supply must be provided:
Model No. 2001EX : 1920 Watts, 230 VAC, 8.4 Amps, 50 Hz.
Model No. 2001BNX: 1920 Watts, 230 VAC, 11 Amps, 50 Hz.
Model No. 2001STX: 1920 Watts, 230 VAC, 11 Amps, 50 Hz.
Your electrician must furnish sufficient current for proper machine operation. We recommend this
popper be connected to a dedicated 15 amp circuit protected line. Failure to wire properly will void
the warranty and can result in damage to the heat elements, light, motor and etc.
It is Gold Medal Products Company’s recommendation that this machine be plugged directly into a
wall outlet. The use of extension cords is not recommended due to safety reasons and the popper’s
performance will be sacrificed/reduced.
Before You Plug In Machine:
1. Make sure that the wall outlet can accept the grounded plug on the power supply cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician inspect the
outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded plug adapter.

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
5
FINAL PREPARATIONS
The popcorn machine was adjusted, inspected, and
tested before it left the factory. After removing machine
from shipping box, remove all tape and packing material
in or on the machine before beginning operation.
OPERATING INSTRUCTIONS
Controls and their functions
LIGHT SWITCH
Turns on all of the lights, interior, and dome on your popcorn machine.
WARMER SWITCH
Operates the forced air popcorn crisping system.
KETTLE HEAT SWITCH
Operates the heating elements in the popping kettle.
KETTLE MOTOR SWITCH
Operates the kettle agitator motor, as well as the exhaust blower in the roof of the machine.
Light
Swi
tch
p/n 42798
Kettle Motor Switch
p/n 42798
Kettle Heat Switch
p/n 42798
Warmer
Switch
p/n 42798

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
6
Amount of Popcorn and Oil:
The Citation popper is equipped with a sixteen ounce corn measure cup. Gold Medal Products
Company recommends the use of flavored and colored coconut oil. Coconut oil does not leave
black deposits in the kettle like other oils.
Corn Charge: 16 Oz. (473 ml)
Oil Charge: 4-5 ounces
Flavacol (Salt): 1 ½ Tablespoon (20 cc) (Use the supplied Salt Scoop)
Popping Instructions:
1. Turn both the KETTLE HEAT and KETTLE MOTOR switches ON.
2. Test pop three (3) kernels of corn and one ounce (1 Oz.) of popping oil. When the kernels pop,
the kettle is ready for use.
3. Load both a full corn/oil charge and Flavacol Seasoning Salt into the kettle. Close the lids.
4. When the corn has finished popping, gently dump the kettle.
5. Repeat the cycle, starting with step number 3, until the desired amount of popcorn has been
achieved. Always pop 3 to 5 consecutive batches for the best popcorn.
On the final kettle of corn, it is a good idea to turn the KETTLE HEAT switch OFF just as the lids are
forced open by the popping corn. This procedure saves electricity, and reduces smoke/odor from
any oil residue that remains after you have finished popping.

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
7
CLEANING INSTRUCTIONS
Clean the Kettle
1. CAUTION: The hot kettle will cause burns if you touch it with your hand. Allow the kettle
to cool for at least 1 hour before attempting to clean. Wipe the kettle with a clean cloth.
2. After ending extended use, mix a gallon of Heat’n Kleen solution (2 tablespoons per
gallon of water). Add 16 oz. of this solution into the kettle. Turn on the kettle heat. When
the water starts to boil, turn off the kettle heat and allow the solution to settle over-
night.
3. Before next use, dump the solution into a bucket and wipe the inside of the kettle with a
clean cloth. Make sure all of the solution goes into the bucket, and that you do not spill
any into the interior cabinet of the machine.
Cleaning the Exhaust Filter (Shown on Page 12 of this manual)
Clean the Exhaust Filter at least once a week by following these simple instructions:
1. Pull the filter out.
2. Wash in warm soap and water.
3. Allow filter to air dry, then re-install.
Clean the Popcorn Machine
1. Wipe the stainless steel parts with a clean cloth and cleaner designed for stainless steel. Do not
use oven cleaners, as they will damage parts of the machine.
2. Ammonia cleaners will damage the plastic doors. Use only non-ammonia cleaners, such as
Gold Medal’s – Watchdog Glass Cleaner – item number 2588.

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
8
TROUBLESHOOTING
Below are some common issues you may encounter, along with basic trouble shooting
steps to resolve them.
EXPERIENCING LONG POPPING CYCLES
If your pop cycle is longer than 4 minutes, it can be the result of several things:
A. LOW VOLTAGE - If the machine is operated on low voltage, this could cause the kettle
not to reach the proper operating temperature. Voltage must be at least 110v.
B. INADEQUATE SUPPLY LINES - Inadequately sized electrical supply lines, in addition to
being a fire hazard, would also prevent the kettle from reaching the proper operating
temperature. Check with a qualified electrician.
C. INFERIOR CORN - Inferior quality corn would result in longer popping cycles. Use only
top quality fresh hybrid popcorn from reputable suppliers. Even then, if you let your corn
pick up moisture or dry out, your popping cycles will be slow.
THE KETTLE DOES NOT HEAT
Before you go any further, make sure the kettle lead-in cord is plugged in.
A. KETTLE HEAT SWITCH - Check the voltage to and from the “KETTLE HEAT” switch,
and if the switch is defective, replace it. (Repair should only be performed by qualified
service personnel.)
THE MOTOR WILL NOT TURN AGITATOR
WARNING! If the kettle agitator shaft is not rotating, DO NOT pop corn. Adjust the clearance
between the kettle bottom and the stir blade to 1/32” (use a dime). Loosen the set screw in the
collars above and below the crossbar and adjust the agitator shaft as necessary. Then re-tighten the
set screws in the collars.

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
9
MAINTENANCE INSTRUCTIONS
DANGER
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
DANGER
Improper installation, adjustment, alteration, service, or maintenance can
cause property damage, injury, or death. Any alterations to this equipment
will void the warranty and may cause a dangerous condition. This appliance
is not intended to be operated by means of an external timer or separate
remote-control system. NEVER make alterations to this equipment. Read the
Installation, Operating, and Maintenance Instructions thoroughly before
installing, servicing, or operating this equipment.
014_020416
WARNING
No user serviceable parts inside. Refer servicing to qualified service
personnel.
011_051514
CAUTION
THE FOLLOWING SECTIONS OF THIS MANUAL ARE INTENDED ONLY
FOR QUALIFIED SERVICE PERSONNEL WHO ARE FAMILIAR WITH
ELECTRICAL EQUIPMENT. THESE ARE NOT INTENDED FOR THE
OPERATOR.
027_010914

Export Citation UniMaxx
Models 2001EX, 2001BNX, 2001STX
10
ORDERING SPARE PARTS
1. Identify the needed part by checking it against the photos, illustrations, and/or the parts list.
2. When ordering, please include part number, part name, and quantity needed.
3. Please include the machine’s model name, serial number, and date of manufacture (located on the
machine nameplate) with your order.
4. Address all parts orders to:
Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
[phone]
[phone]
Fax: [phone]
or, place orders at:
E-mail: [e-mail]
Web Page: www.gmpopcorn.com