Grandview Motorised Rising Screen User manual

Grandview Motorised Rising Screen
User’s Manual
Imported and Distributed in Australia by
Herma Technologies
Factory 4A, 6 Albert St
Preston, VIC 3072
For more information please go to
www.grandviewscreens.com.au
or call 1300 730 025
Aug 2008 v1
Protecting your Screen:
• To ensure long lasting veiwing enjoyment, always
keep the screen rolled up when not in use.
• Keep away from direct sunlight or
high temperatures.
• Examine both the front and back surfaces before
retracting into the case to make sure it is free of
dust, dirt, insects or other foreign matter.
• Use a soft brush or cloth to lightly remove any
foreign particles.
Cleaning your Screen:
• Do not use any solvents, chemicals or abrasive
cleaners on the screen surface.
• Use a mild detergent with warm water to remove
any marks on the surface or screen case.
• Always immediately dab the screen with a soft
cloth to avoid soap marks.
• Do not scrub the surface.
Warranty: 12 Months

Lie the screen flat on the floor as shown.
Step 1
To the Owner:
Congratulations on purchasing a Grandview
Motorised Rising Screen, designed to produce the
sharpest, most pleasing pictures with maximum
convenience.
Important Notes:
• Please read this instruction manual before use
• Please do not attempt to adjust or repair
the product. You will void the warranty
• Please retain this Instruction manual for
future reference
• Ensure the screen is always set up on
even surface
• Never store the screen vertically
• Never operate with anything on top of the screen
Supplied
IR Remote
IR ReceiverPowercord
Step 3
Connect the screen to the power using
the power cord
Step 4
Using IR Remote
Your remote control comes with batteries installed.
To operate your remote:
Press to lift the screen
Press to stop the screen
Press to lower the screen
The Micro switch is used for
retracting or lowering screen in small increments.
Alternatively you may also use the external IR
receiver cable and sensor.
Plug the IR receiver cable into the IR Port on
the casing and mount the sensor in line of
sight with the remote.
Remove the components from the left hand side
compartment as shown below.
(Push the remote to release it from the compartment)
Step 2
Operational Instructions
Infrared Port