Grandview Dynamique R3 User manual

Grandview Screen
DYNAMIQUE
R3 MANUAL

Item Checklist
Step 1: check for boxes and spare parts; total of five boxes
including hardware kit.
Step 2: Check for Decorative Frame parts as listed.
Step 3: Check for Fabric and hardware (springs, screws,
fastening pieces, round-nut, hook, gloves and hanging plates/
magnets)

Step 4. Combine the two pieces of short
silver frame parts with connecting black
bonding pieces. See image for reference.
Frame Installation
Step 4

Steps 5-8. Align with the holes on both sides
and securely fasten with screw. See images
for reference
Frame Installation
Step 5

Step 6

Step 7

Step 8

Step 9. Please note that it is crucial for the
silver frame to have no gap whatsoever. See
image for reference
Frame Installation
Step 9

Steps 10-12. Assembly of corner connection
parts: place corner parts inside the silver
frame and connect the counter part, make
sure the holes are aligned properly. When
installing the two corner pieces, this should
be done simultaneously and inserted at the
same time. See images for reference
Frame Installation
Step 10

Step 11

Step 12

Step 13
Step 13. Please note that it is crucial for the
silver frame to have no gap whatsoever. See
image for reference
Frame Installation

Step 14. As the image points out, if the
position of the silver frame is inaccurate this
will cause any creasing, wrinkle or creases
when installing the fabric.
Frame Installation
Step 14
This image is to show WHAT a IMPROPER
installation would look like.

Step 15. When installing the support bar,
please insert the plastic buckle on both sides.
See image for reference.
Frame Installation
Step 15

Step 16
Step 16. After installing the black piece, this
is what it should look like when it is properly
settled within the silver part.

Step 17
Step 17. There are a total of 7 nuts inside the
silver frame, the one in the middle is for the
support bar, so it will have 3 pieces on both
sides and requires to be fastened with screw.
See image for reference
Frame Installation

Step 18

Step 19

Step 20
Step 20. Unfold the form on the ground
(make sure your ground surface is flat). This
is extremely important because if the fabric is
not flattened nor centered, your screen will
have creases, wrinkles and deformities.
Fabric Installation

Step 21
Step 21. Roll the fabric out so it is facing
down, the shine and fabric should appear as
shown in the image; this is also extremely
important to note that everything should be
as flat as can be; centering everything is
essential to a proper install.