52
Installation
This projection screen should be installed at the best possible viewing position for the audience. Take out
all the parts from the packaging and follow the accessories guideline to ensure you have all parts. The
parts needed will vary depending on which installation you choose to use. For installation on a wood wall
or ceiling, use the 5 x 40 screws. For installation on a drywall, use the 5 x 40 screws with anchors.
Wall Mount
Using a tape measure, to measure the distance between the two keyholes on the casing. ( Figure 1 ).
According to the measurement, use the drill to drill identical holes of the appropriate size (use a smaller
drill bit than the actual screws) on the wall and ensure that it is level ( Figure 2 and 3 ). Screw in the
appropriate screws, either the 5 x 40 for wood walls or the 5 x 40 plus anchors for drywalls, leaving
enough space at the end to hang the casing (Figure 4). To ensure that the screen is level, use a leveller
to check ( Figure 5 ).
The ceiling or wall used forfixture installation must be secure toprevent the screens from falling.
Please read the following as anydamage to the screen surface willaffect the quality of thepicture:
1.Avoid contact or touching the screen surface as it maycause scratches or tears.
2.Do not write or drawon the surface
3.Clean the screen with asoft cloth and lukewarm water. Do not use any detergent or cleaning
products.
Roll up the screen after everyuse.
While the screen is retracting, holdon to the pull loop onthe bottom of the screen toprevent it
from going too fast, which mayresult in damaging both the screenand casing.
It may also cause the screenthe fall.
Ensure that the screen is levelwhen installing; do not pull onthe sides or fold the screen.
To preventunnecessary damage, the operating and maintenanceof the screen should be done
by adults.
Warnings
Do not take apart and replace with unknown parts. If there are any problems, please contact your local dealer.
Product specifications are subject to change.
Ignoring the safety warnings may
lead to injuries and/or damaging
the product.
Fixtures should be installed in a secure
place to avoid accidents or the screen
falling.
Please contact your local dealer for
repair s or maintenance. Please contact
our company if you have any further
questions. Avoid taking apart the
fixtures yourself. Loose parts may
cause the screen to fall.
Roll up the screen after every use.
Leaving it hanging for a long period
of time may cause the fabric to loosen.
Refrain from hanging anything on the
screen as it may cause the screen to
fall.