Hanil T04 User manual

T04
99
4000
Quick Guide T04
Cat. No. : T04
Serial No. Installation Date.
Max. RPM 4,000 rpm
Max. RCF 2,075 xg
Timer
< 100 min or
continuous
Display & Control
Setting RPM / RCF, Time, ACC / DEC
Touch RPM / RCF,
Time, ACC / DEC
Set the desired values by
touching the Up, Down button
Program SAVE / CALL
Touch the Up, Down button to set the desired program number
Touch once : CALL / Touch twice : SAVE(Up to 30)
Display
Status of Speed(RPM / RCF)
Program SAVE/CALL
Touch once : CALL/
Touch twice : SAVE(Up to 30)
Setting Time
Touch once : CALL/
Touch twice : SAVE(Up to 30)
Display window
Status of Time (MIN / SEC)
Program (Call / Save)
Setting Speed
Touch once : RPM / Touch twice : RCF
Start/Stop Lid Open

After Operation
AO-15/10-12 6 x 15 mL or 12 x 10 mL / Max. 4k
30 cm
30 cm
30 cm
Fixed-angle Rotors
140VA
220V 50/60Hz
HI-QG-T04(Rev.0)
Quick Guide T04
Cat. No. : T04
HI-QG-T04(E)(Rev.0)
Order & Inquiry l [phone] l [e-mail] l www.ihanil.com
Service l [phone] l [email protected]
Before Operation
Check the rotor is rmly tightened onto
the motor shaft.
Check the Rotor Locking
After relocating the device or loading the rotor,
balance them by using a leveler. If necessary,
level the device by adjusting the‘Leveling
foot’on the bottom of the device.
Balancing the Centrifuge and Rotor
Cautions For Use
Check the rotor, buckets and tubes are
free of scratch and crack before operation.
Check the Accessories for Abnormalities
Load tubes symmetrically into the
rotor with identical amount.
Load Tubes Symmetrically
Rotor
Electrical Safety
Switch o the device after
use. Unplug the power plug
before cleaning or unused for
a long period of time.
Check the wall outlet
is earth grounded,
surge-protected andcan
supply enough power.
Switch O the DeviceGrounded Outlet
Check the Line Voltage
Maintenance
Connect the device to voltage
sources which correspond to
the electrical requirements on
the label attached to the device.
If the device door cannot be opened, you can activate
the emergency open manually. 1. Wait for rotor to stop
before activating the emergency open. 2. Insert the pin
into the emergency open hole and push it until the door
is opened.
Emergency Lid Open
Keep a safety clearance of 30 cm around the
centrifuge during operation.
Keep a Safety Clearance
Wipe up the moisture in the chamber
with a dry cloth after use. Keep the lid
open when not in use.
Clean the chamber and rotor by wiping
with a cloth soaked in mild detergent and
dry completely.
Keep the Chamber DryCleaning