Hearth & Home COREP-36BK User manual

1
Hearth & Home Technologies • COREP-36BK End Panel Instructions • 2486-931 • 2/17
Corner End Panel
Models: COREP-36BK
Installation Instructions
PREPARATION
1. Remove end panel and decorative front components
from packaging. The appropriate hood(s) for a left or
right-sided corner application have been included with
the end panel. See Figure 1.
Note: The end panel is shipped in either a right or left
corner configuration. Detemine if the configuration re-
ceived is compatible with your application. To convert for
use on an opposite corner model, follow the steps below:
2. Remove existing hood and corner post.
To install corner post, insert tabs into the slots on the
opposite side of the decorative front.
3. Install the appropriate hood by inserting studs into the
holes on the top of the decorative front and corner
post. Attach nuts to secure the hood onto the decora-
tive front. See Figure 1.
INSTALLATION
4. Install 4 shoulder bolts on each side of the appliance.
See Figure 2. Shoulder bolts are supplied with the
decorative front.
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed behind a decorative front.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Figure 1. Install Corner Posts and Hood
SHOULDER BOLT
LOCATIONS
SHOULDER BOLT
LOCATIONS
Figure 2. Install Shoulder Bolts
STUDS STUDS
NUTS NUTS
RIGHT CORNER INSTALLATION
LEFT CORNER INSTALLATION
Hood(s) Included

Hearth & Home Technologies • COREP-36BK End Panel Instructions • 2486-931 • 2/17
2
Figure 4. J-Hook Placement Detail
6. Visually inspect J-Hook connection points to assure
proper placement. See Figure 4.
Figure 5. Install Decorative Fronts
Please contact your Hearth & Home Technologies dealer
with any questions or concerns.
For the location of your nearest Hearth & Home
Technologies dealer,
please visit www.hearhnhome.com.
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearhnhome.com
Figure 6. End Panel and Decorative Front Installed
7. Install decorative front on each side of the appliance
per instructions included with the decorative fronts.
Pull gently on the decorative front and end panel to
ensure that J-Hooks are seated properly and securely
on shoulder bolts. See Figure 5 and Figure 6.
Cleaning Instructions for End Panels and Decorative
Fronts
Use a microfiber cloth and Windex® Original Glass
Cleaner or 03M003 Stove Bright® Glass Cleaner to clean
the end panel and decorative front immediately after
installation to remove acids deposited by the installer or
technician. Spray the cleaner onto the microfiber cloth
and carefully wipe the entire surface. The end panel
and decorative front should be cleaned in this manner
annually by the homeowner to remove fingerprints or
other contaminants. Once oxidation of the paint pigment
has occurred, cleaning will not restore the original color.
Figure 3. Install End Panel
5. Install End panel onto appliance by carefully aligning
J-hooks on back of end panel with slots in vertical end
component of appliance. See Figure 3. End panel will
drop into location with J-hook seated in slot.