Hearth & Home Grand Vista 36 User manual

Hearth & Home Technologies • Grand Vista Mesh Doors • 4060-025 Rev A • 04/08 1
TM
TM
Models:
Grand Vista 36, Grand Vista 42
Mesh Door Kits
Installation
Instructions
These mesh door kits have been tested for use with specific Hearth & Home Technologies products. Check with your local
building code agency before you begin installation to ensure compliance with local codes, including the need for permits
and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of
the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you, please
visit www.hearthnhome.com.
WARNING
Hot screen/mesh and glass doors will cause burns.
• Do not touch screen/mesh or glass doors until cooled
• NEVER allow children to touch screen/mesh or glass
doors
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fireplace.
• Alert children and adults to hazards of high
temperatures.
High temperatures may ignite clothing or other
flammable materials.
• Keep clothing, furniture, draperies and other flammable
materials away.
HOT SURFACES!
Screen/mesh, glass doors and
other surfaces are hot during
operation AND cool down.
NOTICE: All fingerprints and smudges must be wiped clean
from the viewable surfaces of the door kit prior to the initial
burning of the fireplace. If this is not done, these prints and
smudges will be cured into the finish and set for the life of
the fireplace. To keep the finish looking its best, gently wipe
with a soft cloth and if desired, soap and water. Never use
thinner or abrasive cleaners since these products will damage
the finish.
Mesh Door Assembly
Mounting Bracket
Figure 1 Grand Vista Mesh Door Kit
CAUTION! Risk of Cuts/Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.

Hearth & Home Technologies • Grand Vista Mesh Doors • 4060-025 Rev A • 04/08
2
CAUTION! The door kit is heavy. We recommend two
installers to put the front assembly in place.
WARNING! Risk of Fire! DO NOT place combustible mate-
rials on the metal fireplace face or columns.
Slide handle
to the right to open
Figure 4 Completed Door Installation
A. Remove the top door track and discard. Keep the
screws.
B. Remove the existing screens from the fireplace (refer to
Figure 2):
• Remove one screw in each of the screen rods behind
the door track.
• Slide screen rods out of support holes.
• Rods and screen will come out as an assembly.
Discard.
C. Remove three wing nuts and mounting bracket from frame
assembly (refer to Figure 3).
D. Install the mounting bracket with the screws from the door
track.
E. Remove the doors from the frame assembly.
F. Pick up the frame assembly and hook the bottom flange
(refer to Figure 3) over the bottom face of the fireplace.
G. Push the top of the frame assembly against the mounting
bracket. The threaded studs of the frame assembly will
fit through the matching holes of the mounting bracket.
Secure with wing nuts. Refer to Figure 3. Fasten bottom
flange to the fireplace with two screws.
H. Hang the doors.
Bottom
Flange
Threaded
Studs (3) Wing
Nut (3)
Mounting
Bracket
Figure 3 Mounting Bracket - Grand Vista A Box Shown
Screen Rod Screws
Door Track
Figure 2 Remove Existing Screens