Hearth & Home PIER-DV36IN User manual

1
Hearth & Home Technologies • MSFR-36-BK Decorative Front / MSEP-36-BK End Panel Instructions • 2658-912 Rev. B • 4/22
MSFR-36-BK Decorative Front
MSEP-36-BK End Panel
Models: PIER-DV36IN / ST-DV36IN
Installation Instructions
INSTALLATION
The installation process is identical for the ST-DV36IN
and the PIER-DV36IN. Figures show the PIER-DV36IN.
1. Remove end panel and decorative front components
from packaging.
2. Install 4 shoulder bolts on each side of appliance. See
Figure 1. Shoulder bolts are supplied with decorative
fronts.
3. Install vanity panel by placing it inside the appliance
with the front of the panel resting on the bottom lip of the
appliance to conceal the components. See Figure 2.
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed behind a decorative front.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and must be installed for
the protection of children and other at-risk
individuals.
SHOULDER BOLT
LOCATIONS
SHOULDER BOLT
LOCATIONS
Figure 1 Install Shoulder Bolts

2Hearth & Home Technologies • MSFR-36-BK Decorative Front / MSEP-36-BK End Panel Instructions • 2658-912 Rev. B • 4/22
Figure 3. Install End Panel
4. Install End panel onto appliance by carefully aligning
J-hooks on back of end panel with slots in vertical end
component of appliance. See Figure 3. End panel will
drop into location with J-hook seated in slot.
VANITY PANEL
VANITY PANEL INSTALLED
Figure 2 Install Vanity Panel

3
Hearth & Home Technologies • MSFR-36-BK Decorative Front / MSEP-36-BK End Panel Instructions • 2658-912 Rev. B • 4/22
Figure 4 J-Hook Placement Detail
5. Visually inspect J-Hook connection points to assure
proper placement. See Figure 4.
Figure 5 Install Decorative Fronts
Figure 6 End Panel and Decorative Front Installed
6. Install Decorative fronts on each side of appliance per
instructions included with decorative fronts. Pull gently
on both decorative fronts and end panel to ensure that
J-Hooks are seated properly and securely on shoulder
bolts. See Figure 5 and Figure 6.
Cleaning Instructions for End Panels and Decorative
Fronts
Use a microber cloth and Windex® Original Glass
Cleaner or 03M003 Stove Bright® Glass Cleaner to clean
the end panel and decorative front immediately after
installation to remove acids deposited by the installer or
technician. Spray the cleaner onto the microber cloth
and carefully wipe the entire surface. The end panel
and decorative front should be cleaned in this manner
annually by the homeowner to remove ngerprints or
other contaminants. Once oxidation of the paint pigment
has occurred, cleaning will not restore the original color.
Please contact your Hearth & Home Technologies
dealer with any questions or concerns.
For the location of your nearest Hearth & Home Technologies
dealer,
please visit www.hearthnhome.com.
Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.hearthnhome.com