HIK VISION DS-K2600 Series User manual

DS-K2600 Series Controller Connect to Wiegand Reader
DS-K2600 Series Controller Connect To Wiegand Reader
Operation Process
1) Set reader dip switch as wiegand mode.
2) Connect DS-K2600 controller to RS485 reader
3) Check reader LED status
Operation Steps:
1. Set reader dip switch as wiegand mode.
a) The former 4 dip switch are used to configure RS485 address, so in wiegand mode set them as OFF.
b) Set 6th dip switch as ON, the 7th dip switch is for wiegand 26 only, default set as OFF(wiegand34 mode).
2. Connect DS-K2600 to wiegand reader
a) There are 4 ports on the top.
In model K2604, reader1 for door1 entrance, reader2 for door2 entrance, etc.
In model K2602, reader 1 for door1 entrance, reader 2 for door1 exit, 3 for door2 entrance, 4 for door2
exit.
b) Connect red cable to +12V, normally only connect +12V, GND, W0, W1 four cables is enough, if want to
control LED light or buzzer of the reader, please also connect BZ/ERR/OK

DS-K2600 Series Controller Connect to Wiegand Reader
3. Check reader LED status
If BZ/ERR/OK cables are connected, the LED light on reader should blink in blue color, if in red color it means
communication error happens, please check the wiring or dip switch.
Suitable Models:
Model
Description
DS-K2601
Single door access controller
DS-K2602
Two door access controller
DS-K2604
Four door access controller