HIK VISION DS-K4T100 User manual

Title:
DS-K4T100 Electric Bolt Connect to
Access Control Terminal
Version:
v1.0
Date:
3/19/2018
Product:
Access Control Device
Page:
1 of 3
DS-K4T100 Electric Bolt Connect to Access Control
Terminal
Preparation
Connecting electric lock to access control terminal is mainly applied to open the door for exiting. For
electric lock and access control terminal in this document, please check the table below:
Magnetic Lock
Access Control Terminal
DS-K4T100
DS-K1T105, DS-K1T200/201
DS-K1T802, DS-K1T804
DS-K1T500/501
Note
This document is simply used to guide users how to wire correctly and ensure access control terminal can
control locks.
The access control terminal model in this document is DS-K1T201MF-C.
Notice
1. Please cut off power supply before wiring;
2. Please check interfaces of electric lock in following picture;
3. Correspondingly, there are exit button interfaces in DS-K1T200/201/802/804/500/501 series access
control terminal; we will take DS-K1T201F-C terminal as an example:
Color
Description
Red
12V
Black
GND
Green
COM
Yellow
NC
Blue
NO
Interface
Color
NC
White/Purple
COM
White/Yellow
SENSOR
Yellow/Gray

Title:
DS-K4T100 Electric Bolt Connect to
Access Control Terminal
Version:
v1.0
Date:
3/19/2018
Product:
Access Control Device
Page:
2 of 3
Step 1: Wiring
DS-K4T100 & DS-K1T201MF-C
Please connect as the following picture:
2 * DS-K4T100 & DS-K1T201MF-C
Please connect as the following picture:
Step 2: check the lock status
Please suppply power for access control terminal and electric bolt, and please swiping card or press
button, the door will open;
V-
V+
+
-
LOCK
Interface
SENSOR
NC
COM
NO
BUTTON
+
-
SENSOR
BUTTON
NC
COM
NO
LOCK
Interface

Title:
DS-K4T100 Electric Bolt Connect to
Access Control Terminal
Version:
v1.0
Date:
3/19/2018
Product:
Access Control Device
Page:
3 of 3
First Choice for Security Professionals
HIKVISION Technical Support