Home Styles Marco Island 88 5544 42 User manual

Part List
Hardware List
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the wood parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Cam Lock
8 pcs.(+4 extra)
Cam Lock Screw
8 pcs.(+1 extra)
Pull Handle
3 pcs.
1 1/2 Round Head Screw”
3 pcs.(+1 extra)
1 1/4 Flat Head Screw”
24 pcs.(+1 extra)
Tools required for assembly : Phillips screwdriver
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
88 5544 42
Marco Island
Night Stand
(Knock-Down Construction, please refer
to the last page of instructions for steps
to complete drawer assembly)
A.
Top
1 pc.
B.
Side Panel
1 pc.
C.
Side Panel
1 pc. D.
Drawer
3 pcs.
E.
Front rail
1 pc.
F.
Back rail
1 pc.
G.
Back Panel
1 pc.

STEP 1
Assembly Instructions 2/5
Insert Cam Lock Screws
into the pre-drilled holes of
Side Panels (B) and (C).
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
Attach Front Piece (E) and Back Piece (F)
to Side Panel (B) with Cam Locks.
(See Figure 1)
STEP 2
Figure 1
B
C
F
E
B

Assembly Instructions 3/5
Attach Top (A) to unit with Cam Locks.
(See Figure 2)
Slide Back Panel (G) into position.
STEP 3
STEP 4
A
F
B
E
Figure 2
G

Assembly Instructions 4/5
C
STEP 5
STEP 6
Attach Side Panel (C) to unit
with Cam Locks.
(See Figure 3)
Slide Drawers (D) into position.
Figure 3
D
D
D

D5.
Base Part
3 pcs.
D2.
Back Part
3 pcs.
D3.
Side Part
3 pcs.
D4.
Side Part
3 pcs.
Assembly Instructions 5/5
Drawer (D)
Part List
D1.
Front Part
3 pcs.
STEP 1
Attach Side Part (D3) to Front Part
(D1) and Back Part (D2) using 1 1/4”
Flat Head Screws.
STEP 2
Insert Base Part (D5) into the groove.
Attach Side Part (D4) to unit using
1 1/4” Flat Head Screws.
STEP 3
Assemble Pull Handle with
1 1/2 Round Head screw.”
D1
D2
D2
D3
D4
D5
D1