3
CHANGING THE HANDPIECE’S CARTRIDGE
C250 CARTRIDGE RANGE
-Loosen the cartridge screw (1) to release the cartridge.
-Place the cartridge in the solder feed handle.
Important: It is essential to insert the cartridge till the end for a good connection. Use the mark
as reference.
- Align the tip of the cartridge with the solder guide tube (3). Tighten the cartridge screw (1).
- You must leave a gap of 8-10 mm between cartridge tip and the end of the guide tube (2). Loosen the
guide screw (4). Adjust the guide tube and tighten screw (4).
WARNING: It is esential to tighten this screw for the tool to function.
All the cartridges shown are actual size.
Consult our wide range
of cartridges with more
than 250 references in
www.jbctools.com.
For special cartridges
contact with our
distributor.
1
24
3
ø 0,6
1,8x0,8
ø 0,8
2,2x1
ø 1
4,8x1,5
1,2x0,7 3,2x1,5
ø 2,2
2,2 x 1
1,2x0,7 2,2x1
4,8x1,5
ø 2,2
ø 3,8
C250-401 C250-405C250-402 C250-406C250-403 C250-412
C250-404 C250-418C250-409 C250-410
C250-413C250-407 C250-408 C250-411 C250-414 C250-415
8-10 mm
Cartridge screw
Guide tube screw
Alignment
