jbc AL251 User manual

AL251
SOLDERING IRON
www.jbctools.com

2
AL-2A / AL-1A
AL-9A / AL-2AA
SOLDER FEED
STATION
AL-SC
STAND
AL251-A
SOLDERING IRON
Power cord
socket
Equipotential
connection
0964551
Pedal
(optional)
AL251-A
SOLDERING IRON
0780493
ALLEN
AL251 / SOLDERING IRON
INSTALLATION
AL250
SOLDERING IRON
AL251
SOLDERING IRON
ww w.j bc too ls.co m

3
- Loosen the cartridge screw (1) to release the cartridge.
- Place the cartridge in the solder feed handle.
Important: It is essential to insert the cartridge till the end for a good connection. Use the mark
as reference.
- Align the tip of the cartridge with the solder guide tube (3). Tighten the cartridge screw (1).
WARNING: It is esential to tighten (1) screw for the tool to function.
- You must leave a gap of 8-10 mm between cartridge tip and the end of the guide tube (2). Loosen the
guide screw (4). Adjust the guide tube and tighten screw (4).
CHANGING THE HANDPIECE’S CARTRIDGES
AL-IA
HANDS-FREE SOLDERING ARM
AND FUME EXTRACTOR
F4468
FUME EXTRACTOR
ACCESSORIES
1
24
3
8-10 mm
Cartridge screw
Guide tube screw
Alignment

WARRANTY
JBC’s 2 years warranty guarantees this equipment against all manu-
facturing defects, covering the replacement of defective parts and
all necessary labour.
Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,
postage paid, to the dealer where it was purchased enclosing this
fully filled in, sheet.
www.jbctools.com
SERIAL Nº
STAMP OF DEALER
DATE OF PURCHASE
0011700-0812
This product should not be
thrown in the garbage.
All the cartridges shown are
actual size.
Consult our wide range of
cartridges with more than
250 references in
www.jbctools.com
For special cartridges
contact with our distributor.
C250 CARTRIDGE RANGE
ø 0,6
1,8x0,8
ø 0,8 4,8x1,5
1,2x0,7 3,2x1,5
ø 2,2
2,2 x 1
1,2x0,7 2,2x1
4,8x1,5
ø 2,2
ø 3,8
2,2x1
ø 1,7
ø 1
C250-401 C250-405C250-402 C250-406C250-403 C250-412 C250-404 C250-418C250-409 C250-410
C250-413C250-407 C250-408 C250-411 C250-414 C250-415