JLL CT300 User manual

CT300 RESISTANCE INSTRUCTIONS
If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
1 X MULTI TOOL 1 X MULTI TOOL SPANNER 1 X CRANK REMOVAL TOOL
TOOLS
INSTRUCTIONS
Start by removing the left
side bolt securing the
swing arm
1
Remove the left rear
stabilizer bolt
2
Remove all the screws
from the left side
3

Make sure to remove the left swing arm before removing the casing.
If you are finding it difficult to turn the bolts then a pair of pliers should be used.
The pliers and crank removal tool are not a part of the assembly kit.
ADVICE
Once the casing is off
remove the cap from
the center of the wheel
4
Insert the black end
and turn clockwise
7
Now screw the top nut
clockwise down the
thread
10
Remove the left side
wheel
8
Push up the magnets
and screw the bottom
nut clockwise down
the thread
9
Using the crank removal
tool insert the silver
end
5
Turn the tool
anticlockwise
6